A new method for reducing operation time and radiation exposure in the placement of Jamshidi needles: Technical note

Percutaneous pedicle screws have been used in the treatment of thoracolumbar fractures for decades, and conventional fluoroscopy is commonly used to confirm the positions of the Jamshidi needles during the procedure. In this article, a modified method is reported for the placement of Jamshidi needles. The attending surgeons did not receive any radiation during the procedure and the fluoroscopy time for the patients was little. In our method, all six Jamshidi needles were placed on the pedicles and hammered 2 mm into each entry site. When the verification images were acquired, the medical personnel went behind a lead-lined wall. The positions of the needles were first reviewed and adjusted as needed based on the anterior-posterior (AP) image. Then, the C-arm was rotated and lateral images were obtained to further verify the needle placement. The rest of the screw placement procedure remained the same. The proposed technique was applied in 45 patients with thoracolumbar fractures. It took an average (range) of 5 (4-7) single-shot images to ensure all the needles were positioned at the ideal entry site and 12 (10-17) minutes to complete this step. No neurological symptoms were reported by the patients. Using the proposed technique, the radiation exposure for the surgeons is zero, and the patients are well-protected from excessive radiation exposure. This modified method of embedding all the Jamshidi needles at the entry sites before fluoroscopy is an improved technique compared with the conventional method.