Evaluation of a sport-specific field test to determine maximal lactate accumulation rate and sprint performance...

The aim of this study was to examine the reliability of maximal lactate accumulation rate (V˙La_max) and sprint performance parameters in running and assess different approaches to determine alactic time interval (t_alac).

Sixteen competitive runners (female=5; male=11) performed three trials (T1, T2 and T3) of an all-out 100-m sprint test separated by 48h.

Time to cover the 100m was determined by using a photoelectric light-barrier (t_100,LB) and a stop-watch (t_100,SW). Throughout the sprints, velocity was measured using a laser velocity guard (LAVEG) to estimate maximal velocity (v_max) and power (P_max). The t_alac was calculated as the time when power decreased by 3.5% (t_pmax-3.5%) and interpolated based on the sprint time (t_inter,LB and t_inter,SW). Reliability was assessed using intraclass correlation coefficient (ICC), typical error (TE) and smallest worthwhile change (SWC).

After initial familiarisation, t₁₀₀, t_inter, v_max, P_max and V˙La_max attained excellent reliability (ICC≥0.90), whereas t_pmax-3.5% attained moderate reliability (ICC=0.518). The reliability of V˙La_max was higher when t_inter,LB or t_inter,SW were used (ICC=0.960) compared to using t_pmax-3.5% (ICC=0.928). At T1, V˙La_max was significantly higher when stop-watch measurements were used. There was no difference between t_pmax-3.5% and the interpolated time intervals and the associated V˙La_max-estimates.

In running, V˙La_max and sprint performance parameters can easily and high-reliably be measured using this sport-specific field test. Interpolating t_alac results in similar and more reliable values of V˙La_max. To improve the reliability and accuracy of the stop-watch estimate, a familiarisation should be performed.