Impact of Amorphous-C/Ni Multilayers on Ni-Induced Layer Exchange for Multilayer Graphene on Insulators

Hiromasa Murata1, Noriyuki Saitoh2, Noriko Yoshizawa2

  • 1Institute of Applied Physics, University of Tsukuba, 1-1-1 Tennodai, Tsukuba, Ibaraki 305-8573, Japan.

ACS Omega
|September 12, 2019
PubMed

Related Concept Videos

Inkjet-printed Polyvinyl Alcohol Multilayers05:11

Inkjet-printed Polyvinyl Alcohol Multilayers

An inkjet printer was used to manufacture polyvinyl alcohol multilayers. Polyvinyl alcohol water-based ink was formulated, and the main physical properties were investigated.
13.0K
Construction of a Multilayered Mesenchymal Stem Cell Sheet with a 3D Dynamic Culture System07:44

Construction of a Multilayered Mesenchymal Stem Cell Sheet with a 3D Dynamic Culture System

This article provides an efficient and feasible method for constructing multilayered stem cell sheets with favorable stem cell property.
7.9K
Using Multilayered Hydrogel Bioink in Three-Dimensional Bioprinting for Homogeneous Cell Distribution06:29

Using Multilayered Hydrogel Bioink in Three-Dimensional Bioprinting for Homogeneous Cell Distribution

Here, we developed a novel multilayered modified strategy for liquid-like bioinks (gelatin methacryloyl with low viscosity) to prevent the sedimentation of encapsulated...
7.1K
Design and Development of a Three-Dimensionally Printed Microscope Mask Alignment Adapter for the Fabrication of Multilayer Microfluidic Devices06:21

Design and Development of a Three-Dimensionally Printed Microscope Mask Alignment Adapter for the Fabrication of Multilayer Microfluidic Devices

This project allows small laboratories to develop an easy-to-use platform for the fabrication of precise multilayer microfluidic devices. The platform consists of a three-dimensionally printed microscope mask alignment adapter using which multilayer microfluidic devices with alignment errors of <10 µm were...
3.3K
Production of Single Tracks of Ti-6Al-4V by Directed Energy Deposition to Determine the Layer Thickness for Multilayer Deposition09:12

Production of Single Tracks of Ti-6Al-4V by Directed Energy Deposition to Determine the Layer Thickness for Multilayer Deposition

In this research, a rapid method based on melt pool characterization is developed to estimate the layer thickness of Ti-6Al-4V components produced by directed energy...
9.7K
Multi-step Variable Height Photolithography for Valved Multilayer Microfluidic Devices10:18

Multi-step Variable Height Photolithography for Valved Multilayer Microfluidic Devices

Multilayer microfluidic devices often involve the fabrication of master molds with complex geometries for functionality. This article presents a complete protocol for multi-step photolithography with valves and variable height features tunable to any application. As a demonstration, we fabricate a microfluidic droplet generator capable of producing hydrogel beads.
15.0K