Related Experiment Video
Updated: Jan 19, 2026

Simulation of Human-induced Vibrations Based on the Characterized In-field Pedestrian Behavior
Published on: April 13, 2016
Validation of a simplified human body model in relaxed and braced conditions in low-speed frontal sled tests
Karan Devane1,2, Dale Johnson1,2, F Scott Gayzik1,2
1Biomedical Engineering, Wake Forest School of Medicine, Winston-Salem, North Carolina.
Abstract:
Objective: The goal of this study was to implement active musculature into the Global Human Body Models Consortium (GHBMC) average male simplified occupant model (M50-OS v2) and validate its performance in low-speed frontal crash scenarios.Methods: Volunteer and postmortem human subjects (PMHS) data from low-speed frontal sled tests by Beeman et al., including 2.5 and 5.0 g acceleration pulses, were used to simulate events in LS-DYNA. All muscles were modeled as 1D beam elements and assigned a Hill-type muscle material. From the output of proportional-integral-derivative (PID) controllers, the activation level for each muscle was calculated using a sigmoid function, representing the firing rate of motor neurons. The PID controller attempts to preserve the initial posture of the model. Percentage muscle contribution for all skeletal muscles was precalculated using the M50-OS with active muscles (M50-OS + Active). The M50-OS + Active employs varying levels of neural delays to represent volunteer relaxed and braced conditions, taken from literature. Braced condition experiments were simulated using elevated joint angle set values for the PID controller. The M50-OS + Active model was used to simulate 2 muscle conditions (relaxed and braced) at 2 pulse severities (2.5 and 5.0 g). A control set of simulations was conducted to compare the effect of adding active muscle. Ten whole-body simulations were conducted.Results: The results from volunteer simulations showed a strong dependence of reaction loads and kinematics on muscle activation. Compared to baseline, M50-OS, at 5.0 g acceleration, 33.3% and 7.6% decreases were observed in the overall head kinematics of the M50-OS + Active for the braced and relaxed conditions, respectively. Regarding the anterior direction, similar reductions in overall kinematics were observed for both volunteer test conditions. In comparison to control simulations in which no active muscle was implemented, objective evaluation scores increased markedly at both speeds for the braced condition. Little to no gain was found in the relaxed condition.Conclusions: The results justify the need for use of an active human body model for predicting low-speed frontal kinematics, particularly in the braced condition. Head kinematics were reduced when using active modeling for all simulations (braced and relaxed).
Related Concept Videos
General Case of Eccentric Axial Loading
Consider a member subjected to equal and opposite forces that are applied along a line that does not coincide with the member's neutral axis. In unsymmetrical...
Clearance Models: Physiological Models
The organ's clearance rate depends on the blood flow to the organ and the extraction ratio (E). The extraction ratio describes the organ's...
Deformation of Member under Multiple Loadings
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...
Rigid Body Equilibrium Problems - II
Consider two children sitting on a seesaw, which has negligible mass. The first child has a mass (m1) of 26 kg and sits at point A, which is 1.6 meters (r1) from the pivot point B; the second child has a mass (m2) of 32 kg and sits at point C. How far from the pivot point B should the second child sit (r2) to balance the seesaw?
Normal Strain under Axial Loading
Eccentric Axial Loading in a Plane of Symmetry

