Thermo-Mechanical Coupling Analyses for Al Alloy Brake Discs with Al₂O₃-SiC_(3D)/Al Alloy Composite Wear-Resisting...

In the present work, a theoretical model of three-dimensional (3D) transient temperature field for Al alloy brake discs with Al₂O₃-SiC_(3D)/Al alloy wear-resisting surface layer was established. 3D transient thermo-stress coupling finite element (FE) and computational fluid dynamic (CFD) models of the brake discs was presented. The variation regularities of transient temperature and internal temperature gradient of the brake discs under different emergency braking conditions were obtained. The effects of initial braking velocity (IBV) and thickness of Al₂O₃-SiC_(3D)/Al alloy composite wear-resisting layer on the maximum friction temperature evolution of the disc were discussed. The results indicated the lower temperature and thermal stress distributed uniformly on the wear-resisting surface, which was dominated by high conductivity and cooling ability of the Al alloy brake disc. The maximum friction temperature was not obviously affected by the thickness of the wear-resisting layer. The maximum friction temperature of the brake discs increased with the increase of the IBV, the maximum friction temperature and thermal stress of the brake discs is about 517 °C and 192 MPa at IBV = 97 m/s considering air cooling, respectively. The lower thermal stress and fewer thermal cracks are produced during the braking process, which relatively decrease the damage. The friction behavior of the tribo-couple predicted using FE method correlated well with the experimental results obtained by sub-scale testing.