Validity of Maternal Report of Birthweight in a Cohort Study and Its Implication on Low Birthweight Rate Using

Akshay Swaminathan1, Tinku Thomas2, Daniel J Corsi3

  • 1Department of Statistics, Harvard College, Cambridge, Massachusetts, USA.

Indian Pediatrics
|November 16, 2019
PubMed
Abstract

Related Concept Videos

Regression Toward the Mean01:52

Regression Toward the Mean

Regression toward the mean (“RTM”) is a phenomenon in which extremely high or low values—for example, and individual’s blood pressure at a particular moment—appear closer to a group’s average upon remeasuring. Although this statistical peculiarity is the result of random error and chance, it has been problematic across various medical, scientific, financial and psychological applications. In particular, RTM, if not taken into account, can interfere when...
6.8K
z Scores and Area Under the Curve01:17

z Scores and Area Under the Curve

z scores are the standardized values obtained after converting a normal distribution into a standard normal distribution. A z score is measured in units of the standard deviation. The z score tells you how many standard deviations the value x is above (to the right of) or below (to the left of) the mean, μ. Values of x that are larger than the mean have positive z scores, and values of x that are smaller than the mean have negative z scores. If x equals the mean, then x has a z score of...
18.0K
Bias in Epidemiological Studies01:29

Bias in Epidemiological Studies

Biases can arise at various stages of research, from study design and data collection to analysis and interpretation. Recognizing and addressing these biases is essential to ensure the validity and reliability of epidemiological findings.Broadly speaking, biases in epidemiology fall into three main categories: selection bias, information bias, and confounding. A more detailed description of possible biases is:  
1.2K
Testing a Claim about Mean: Known Population SD01:11

Testing a Claim about Mean: Known Population SD

A complete procedure of testing the hypothesis about a population mean is explained here.
Estimating a population mean requires the samples to be distributed normally. The data should be collected from the randomly selected samples having no sampling bias. The sample size needed to be higher than 30, and most importantly, the population standard deviation should be already known.
In most realistic situations, the population standard deviation is often unknown, but in rare circumstances, when it...
3.1K
Estimating Population Mean with Unknown Standard Deviation01:22

Estimating Population Mean with Unknown Standard Deviation

In practice, we rarely know the population standard deviation. In the past, when the sample size was large, this did not present a problem to statisticians. They used the sample standard deviation s as an estimate for σ and proceeded as before to calculate a confidence interval with close enough results. However, statisticians ran into problems when the sample size was small. A small sample size caused inaccuracies in the confidence interval.
William S. Gosset (1876–1937) of the...
8.7K
Estimating Population Standard Deviation01:26

Estimating Population Standard Deviation

When the population standard deviation is unknown and the sample size is large, the sample standard deviation s is commonly used as a point estimate of σ. However, it can sometimes under or overestimate the population standard deviation. To overcome this drawback, confidence intervals are determined to estimate population parameters and eliminate any calculation bias accurately. However, this only applies to random samples from normally distributed populations. Knowing the sample mean and...
3.3K