Related Experiment Video
Updated: Jan 1, 2026

The Terroir Concept Interpreted through Grape Berry Metabolomics and Transcriptomics
Published on: October 5, 2016
Compositional Characterization of Different Industrial White and Red Grape Pomaces in Virginia and the Potential
Qing Jin1, Joshua O'Hair1, Amanda C Stewart1
1Department of Food Science and Technology, Virginia Polytechnic Institute and State University, 1230 Washington St. SW, Blacksburg, VA 24061, USA.
Abstract:
To better evaluate potential uses for grape pomace (GP) waste, a comprehensive chemical composition analysis of GP in Virginia was conducted. Eight commercial white and red pomace samples (cv. Viognier, Vidal Blanc, Niagara, Petit Manseng, Petit Verdot, Merlot, Cabernet Franc, and Chambourcin) obtained from different wineries in Virginia, USA were used. For extractives, GPs contained 2.89%-4.66% titratable acids, 4.32%-6.60% ash, 4.62%-12.5% lipids with linoleic acid being the predominant (59.0%-70.9%) fatty acid, 10.4-64.8 g total phenolic content (gallic acid equivalents)/kg GP, 2.09-53.3 g glucose/kg GP, 3.79-52.9 g fructose/kg GP, and trace sucrose. As for non-extractives, GPs contained 25.2%-44.5% lignin, 8.04%-12.7% glucan, 4.42%-7.05% xylan, and trace amounts of galactan, arabinan, and mannan (less than 3% in total). Potential usages of these components were further examined to provide information on better valorization of GP. Considering the valuable extractives (e.g., polyphenols and oil) and non-extractives (e.g., lignin), designing a biorefinery process aiming at fully recover and/or utilize these components is of future significance.
More Related Videos
Related Concept Videos
Vicinal Diols via Reductive Coupling of Aldehydes or Ketones: Pinacol Coupling Overview
Moisture Content and Bulking of Aggregate
When aggregates are exposed to rain or sit in stockpiles, they absorb moisture, which must be...
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
Specific Gravity of Aggregate
Bulk or gross specific gravity is calculated by taking the ratio of the mass of aggregates in the saturated surface-dry state to the total volume that includes both the solids and the voids within the...
Factors Affecting Workability

