Related Experiment Video

Updated: Jan 1, 2026

Reconfigurable Microfluidic Channel with Pin-discretized Sidewalls
10:39

Reconfigurable Microfluidic Channel with Pin-discretized Sidewalls

Published on: April 12, 2018

7.8K

A new type of artificial water channels

Aleksandr Noy1,2, Meni Wanunu3

  • 1Physical and Life Sciences Directorate, Lawrence Livermore National Laboratory, Livermore, CA, USA. noy1@llnl.gov.

Nature Nanotechnology
|December 20, 2019
PubMed
Abstract

No abstract available in PubMed .

More Related Videos

One-Step Approach to Fabricating Polydimethylsiloxane Microfluidic Channels of Different Geometric Sections by Sequential Wet Etching Processes08:31

One-Step Approach to Fabricating Polydimethylsiloxane Microfluidic Channels of Different Geometric Sections by Sequential Wet Etching Processes

Published on: September 13, 2018

10.3K
Procedure for the Development of Multi-depth Circular Cross-sectional Endothelialized Microchannels-on-a-chip10:55

Procedure for the Development of Multi-depth Circular Cross-sectional Endothelialized Microchannels-on-a-chip

Published on: October 21, 2013

14.3K

Related Concept Videos

Design Example: Design of an Irrigation Channel01:27

Design Example: Design of an Irrigation Channel

Trapezoidal channels are widely used in irrigation systems due to their cost-effectiveness and efficiency in conveying water. Trapezoidal channels feature a flat bottom and sloping sides, making them stable and easier to construct compared to other shapes. The bottom width and side slope ratio are determined based on the required flow capacity and site conditions. The side slope is kept gentle for unlined channels to prevent soil erosion.Hydraulic parameters in channel design include the flow...
704
Aquaporins01:25

Aquaporins

Aquaporins or AQPs are a family of integral membrane proteins whose primary function is to transport water, while some called aquaglyceroporins also transport glycerol. In addition, aquaporins have also been suspected to be involved in transporting volatile substances, such as carbon dioxide and ammonia, across membranes. Such AQPs that act as gas channels are often highly expressed in cells involved in the gaseous exchange, such as red blood cells, epithelial cells, and pulmonary capillaries.
6.0K
Weir01:24

Weir

A weir is a hydraulic structure designed to partially obstruct an open channel, enabling precise control and measurement of water flow. By forcing water to flow over or through it, a weir allows for accurate determination of discharge rates, making it an essential tool in water resource management. These structures are extensively used in regulating river flows, irrigation systems, and flood control channels.Types of Weirs and Their FeaturesWeirs are categorized primarily into sharp-crested and...
404
Regulation of Water Output01:26

Regulation of Water Output

The human body predominantly expels water through the urinary system. On average, an individual generates around 1.5 liters of urine each day. This amount can fluctuate based on how well a person is hydrated, but a critical minimum quantity of urine must be produced to ensure the body's proper functioning. Daily, the kidneys remove 600 to 1200 milliosmoles of dissolved substances, effectively excreting excess minerals and water-soluble toxins such as creatinine, urea, and uric acid from the...
1.9K
Rapidly Varying Flow01:24

Rapidly Varying Flow

Rapidly varying flow (RVF) in open channels is characterized by abrupt changes in flow depth over a short distance, with the rate of depth change relative to distance often approaching unity. These flows are inherently complex due to their transient and multi-dimensional nature, making exact analysis difficult. However, approximate solutions using simplified models provide valuable insights into their behavior.Key Features of Rapidly Varying FlowRVF is commonly observed in scenarios involving...
359
States of Water01:23

States of Water

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
55.8K