Comparison of optimized intensity correction methods for ²³Na MRI of the human brain using a 32-channel phased array...

To correct for the non-homogeneous receive profile of a phased array head coil in sodium magnetic resonance imaging (²³Na MRI).

²³Na MRI of the human brain (n = 8) was conducted on a 7T MR system using a dual-tuned quadrature ¹H/²³Na transmit/receive birdcage coil, equipped with a 32-channel receive-only array. To correct the inhomogeneous receive profile four different methods were applied: (1) the uncorrected phased array image and an additionally acquired birdcage image as reference image were low-pass filtered and divided by each other. (2) The second method substituted the reference image by a support region. (3) By averaging the individually calculated receive profiles, a universal sensitivity map was obtained and applied. (4) The receive profile was determined by a pre-scanned large uniform phantom. The calculation of the sensitivity maps was optimized in a simulation study using the normalized root-mean-square error (NRMSE). All methods were evaluated in phantom measurements and finally applied to in vivo ²³Na MRI data sets. The in vivo measurements were partial volume corrected and for further evaluation the signal ratio between the outer and inner cerebrospinal fluid compartments (CSF_out:CSF_in) was calculated.

Phantom measurements show the correction of the intensity profile applying the given methods. Compared to the uncorrected phased array image (NRMSE = 0.46, CSF_out:CSF_in = 1.71), the quantitative evaluation of simulated and measured intensity corrected human brain data sets indicates the best performance utilizing the birdcage image (NRMSE = 0.39, CSF_out:CSF_in = 1.00). However, employing a support region (NRMSE = 0.40, CSF_out:CSF_in = 1.17), a universal sensitivity map (NRMSE = 0.41, CSF_out:CSF_in = 1.05) or a pre-scanned sensitivity map (NRMSE = 0.42, CSF_out:CSF_in = 1.07) shows only slightly worse results.

Acquiring a birdcage image as reference image to correct for the receive profile demonstrates the best performance. However, when aiming to reduce acquisition time or for measurements without existing birdcage coil, methods that use a support region as reference image, a universal or a pre-scanned sensitivity map provide good alternatives for correction of the receive profile.