A Front-Side Microfabricated Thermoresistive Gas Flow Sensor for High-Performance, Low-Cost and High-Yield Volume...

In this paper, we present a novel thermoresistive gas flow sensor with a high-yield and low-cost volume production by using front-side microfabricated technology. To best improve the thermal resistance, a micro-air-trench between the heater and the thermistors was opened to minimize the heat loss from the heater to the silicon substrate. Two types of gas flow sensors were designed with the optimal thermal-insulation configuration and fabricated by a single-wafer-based single-side process in (111) wafers, where the type A sensor has two thermistors while the type B sensor has four. Chip dimensions of both sensors are as small as 0.7 mm × 0.7 mm and the sensors achieve a short response time of 1.5 ms. Furthermore, without using any amplification, the normalized sensitivity of type A and type B sensors is 1.9 mV/(SLM)/mW and 3.9 mV/(SLM)/mW for nitrogen gas flow and the minimum detectable flow rate is estimated at about 0.53 and 0.26 standard cubic centimeter per minute (sccm), respectively.