Preparation and Properties of Wood Tar-based Rejuvenated Asphalt

In order to explore the applicability of the rejuvenated asphalt with wood tar as the main raw material, the orthogonal test was used to determine the optimal ratio of wood tar-based rejuvenator. The physical properties, rheological properties and components of matrix asphalt, aged asphalt, wood tar-based rejuvenated asphalt and commercial RA-102# rejuvenated asphalt were tested and compared. The results show that the optimal ratio of wood tar-based rejuvenator is 15wt% wood tar, 0.3wt% biomass fiber, 5wt% plasticizer, 0.3wt% compatibilizer, and 1wt% stabilizer of the mass of aged asphalt. Wood tar-based rejuvenator can restore the physical properties of the aged asphalt to meet the specification requirements. The synergistic effect of biomass fiber and plasticizer make the wood tar-based rejuvenated asphalt has good resistance to accumulated permanent deformation, but its low-temperature cracking resistance needs to be further improved. During the rejuvenation process of aged asphalt, the colloidal state changes from gel-state to sol-state, characterizing that the viscosity of asphalt decreased and the fluidity increased. Wood tar-based rejuvenator can react with aged asphalt to weaken the vibration strength of carbonyl and sulfoxide groups, so as to realize the recovery of service performance. Wood tar-based rejuvenator has better environmental protection and applicability, which is worthy of further study and promotion.