Research: Comparing ASTM F1671 with a Modified Dot-Blot Method to Evaluate Personal Protective Materials

Effective personal protective equipment (PPE) is critical in preventing the spread of infectious diseases. Appropriate test systems and test soils are needed to adequately evaluate PPE. ASTM test method F903, which specifies the test method setup also used in ASTM F1670 and F1671, has been used for decades to test liquid (ASTM F1670) or viral (ASTM F1671) penetration resistance of PPE fabrics. However, an alteration of the bacteriophage propagation method detailed in the standard was necessary to obtain consistent titers of virus. In this study, modification of the nutrient broth provided consistently higher titers of virus and the use of the top agar in smaller increments prevented premature solidification. This study then compared the standard ASTM F1671 (using bacteriophage ϕχ174) with a modified dot-blot method to assess viral penetration of PPE materials. The results indicated that ASTM F1671 and the dot-blot apparatus methods were equivalent. The dot-blot method described here is less labor intensive and faster than the ASTM F1671 method. However, using the dot-blot system, which uses antibodies to detect the bacteriophage and signal amplification, does not indicate if virus viability or infectivity is retained, whereas the ASTM F1671 method indicates both. Nonetheless, the method presented in this investigation is a substantial improvement of a standard method for viral challenge testing of PPE materials.