Related Experiment Video
Updated: Dec 25, 2025

Collection and Extraction of Occupational Air Samples for Analysis of Fungal DNA
Published on: May 2, 2018
A needle trap device method for sampling and analysis of semi-volatile organic compounds in air
Hongwan Li1, Chenyang Bi1, Xiaofeng Li2
1Department of Civil, Architectural and Environmental Engineering, The University of Texas at Austin, TX, USA.
Abstract:
Semi-volatile organic compounds (SVOCs), such as phthalates, organophosphates, and polybrominated diphenyl ethers, are emerging as an important class of pollutants that are of serious health concerns. Determining concentrations of these pollutants is of great importance for environmental and exposure studies. In this work, a needle trap device (NTD) method was developed to measure the concentration of SVOCs in air samples. Sorbents were packed in the NTD to capture SVOCs with the aid of a sampling pump. NTD operational parameters, such as desorption temperature, desorption time, and sampling flow rate, were optimized for the target SVOCs. The limit of detection for air sampling by the NTD method ranged between 5 pg and 1 ng, depending on the SVOC compound. The variations in terms of NTD repeatability and reproducibility were lower than 14% for all cases. In addition, the influence of other experimental parameters, such as sampling temperature and humidity, breakthrough volume, NTD storage time, as well as carryover effect were examined. Finally, NTDs were used to determine emissions of gas-phase SVOCs from various consumer products in an emission cell and to collect total airborne SVOC samples (gas and particle phases) in an office. The results of NTD method were in an agreement with data obtained by conventional active sampling methods using Tenax® sorbent tubes and polyurethane foam samplers, but with improvements of relative standard deviation, sensitivity, and sampling time. The results demonstrated that the NTD method is a simple, sensitive, effective, reusable, and inexpensive technique for sampling and analyzing SVOCs in the concentration range from 2 ng m-3 to 100 μg m-3 in air.
More Related Videos
07:57Quantitative Detection of Trace Explosive Vapors by Programmed Temperature Desorption Gas Chromatography-Electron Capture Detector
Published on: July 25, 2014
07:32Detection of 3-Nitrotyrosine in Atmospheric Environments via a High-performance Liquid Chromatography-electrochemical Detector System
Published on: January 30, 2019
Related Concept Videos
Sampling Methods: Sample Types
Solid samples include a variety of substances, such as sediments from water bodies, soil, metals, and biological tissues. Two standard methods for extracting sediments from water bodies are grab sampling and piston coring. Grab sampling involves using a device to collect a discrete sediment sample from the bottom of a water body with minimal disturbance. Grab samples do not always represent the entire area due to...
Sample Preparation for Analysis: Overview
Bulk or large solid samples are typically reduced in size using grinding, crushing, or milling techniques to increase the...
Gas Chromatography: Types of Detectors-II
Volatilization
Gas Chromatography: Sample Injection Systems
Two primary injection methods are used...
Atomic Absorption Spectroscopy: Atomization Methods