Determination of CHLORPYRIFOS by GC/ECD in water and its sorption mechanism study in a RHODIC FERRALSOL

The validation of chromatographic methods is a costly process, however necessary, especially with regard to the validation of methods that accurately determine concentrations of pesticides in different environmental compartments. This research aimed at the development and validation of a simple and fast method for the determination of chlorpyrifos concentrations in water by means of a gas chromatograph with electron capture detection (GC/ECD), and to investigate chlorpyrifos dynamics of adsorption in a Rhodic Ferralsol in Southern Brazilian conditions. The developed chromatographic method was based in EPA 8141 method. Parameters to be checked for method validation were: Selectivity/specificity, linearity, precision, accuracy, robustness, limit of detection (LOD) and limit of quantitation (LOQ). Were employed the following methodologies for the validation process: ANVISA Resolution 899, DOQ-CGCRE-008 and FDA Bioanalytical Method Validation Guide. Also, through laboratory tests, the sorption dynamics of chlorpyrifos in Rhodic Ferralsol was evaluated. Thus, the soil was contaminated with increasing concentrations of chlorpyrifos, which were subjected to solid-liquid extraction with SPE cartridge Chromabond® C18 ec. The obtained results were submitted to the models of Langmuir, Freundlich, Dubinin-Radushkevich and Sips. By this method, chlorpyrifos peaks are obtained at 16.9 min, demonstrating practicality and low cost. This method exhibits precision and sensitivity, with satisfactory LQ and LQ values. The models of Langmuir, Freundlich, Dubinin-Radushkevich and Sips suggest the occurrence of simultaneous adsorption in mono and multilayer of chlorpyrifos in Rhodic Ferralsol colloids, as well as the predominance of a chemical, high energy binding process (irreversible). However, the chemisorption of chlorpyrifos is more related to the good fit found for Dubinin-Radushkevich sorption energy values (9.861 and 11.079 KJ mol^-1) and Q_m values estimated by Langmuir (485.55 and 389.61 μg g^-1 for linear and nonlinear model).