Related Experiment Video
Updated: Dec 18, 2025

Temperature-programmed Deoxygenation of Acetic Acid on Molybdenum Carbide Catalysts
Published on: February 7, 2017
Thermodynamics of Hydrochloric Acid in 80 Weight Percent 2-Methoxyethanol and 20 Weight Percent Water From 10 to 50
Harry P Thun1, Bert R Staples1, Roger G Bates1
1Institute for Materials Research, National Bureau of Standards, Washington, D.C. 20234.
Abstract:
Electromotive-force measurements of cells of the type Pt, H2|HCl(m) in 2-methoxyethanol + H2O|AgCl, Ag at nine temperatures ranging from 10 to 50 °C were used to derive (a) the standard emf of the cell in 80 weight percent 2-methoxyethanol (methylcellosolve), (b) the activity coefficient of HCl, (c) the relative partial molal enthalpy and heat capacity of HCl, and (d) the thermodynamic constants for the transfer of HCl from water to 80 weight percent methylcellosolve. The molality of the acid ranged from 0.006 to 0.106 mol kg-1. To obtain the standard emf it was necessary to correct for ion-pair formation and to use the extended terms of the Debye-Hiickel theory. The standard emf varied with temperature (t, °C) according to the equation . Vapor pressures and dielectric constants for this mixture were measured over the temperature range. At 25 °C the solvent has a vapor pressure of 2506.5 Nm-2 (18.8 mm Hg) and a dielectric constant of 31.5.
Related Concept Videos
Titration Calculations: Strong Acid - Strong Base
A titration is carried out for 25.00 mL of 0.100 M HCl (strong acid) with 0.100 M of a strong base NaOH. The pH at different volumes of added base solution can be calculated as follows:
(a) Titrant volume = 0 mL. The solution pH is due to the acid ionization of HCl. Because this is a strong acid, the ionization is complete and the hydronium ion molarity is 0.100 M. The pH of the solution is then:
Titration of a Weak Base with a Strong Acid
Using the ICE table and substituting the Kb value, we calculate the initial pH of 50 mL of 0.1 M ammonia to be 11.11. Addition of 25 mL of 0.1 M hydrochloric acid to this solution of ammonia results in a buffer with an equal concentration of ammonia and ammonium ions. The pH of this buffer can be calculated by substituting these...
Constant Pressure Calorimetry
Acid-Catalyzed Hydration of Alkenes
Hess's Law
Weak Acid Solutions

