Related Experiment Video
Updated: Dec 18, 2025

Proof-of-Concept for Gas-Entrapping Membranes Derived from Water-Loving SiO2/Si/SiO2 Wafers for Green Desalination
Published on: March 1, 2020
Skin hydrophobicity as an adaptation for self-cleaning in geckos
Jendrian Riedel1, Matthew John Vucko1, Simone P Blomberg2
1College of Science and Engineering James Cook University Townsville Qld. Australia.
Abstract:
Hydrophobicity is common in plants and animals, typically caused by high relief microtexture functioning to keep the surface clean. Although the occurrence and physical causes of hydrophobicity are well understood, ecological factors promoting its evolution are unclear. Geckos have highly hydrophobic integuments. We predicted that, because the ground is dirty and filled with pathogens, high hydrophobicity should coevolve with terrestrial microhabitat use. Advancing contact-angle (ACA) measurements of water droplets were used to quantify hydrophobicity in 24 species of Australian gecko. We reconstructed the evolution of ACA values, in relation to microhabitat use of geckos. To determine the best set of structural characteristics associated with the evolution of hydrophobicity, we used linear models fitted using phylogenetic generalized least squares (PGLS), and then model averaging based on AICc values. All species were highly hydrophobic (ACA > 132.72°), but terrestrial species had significantly higher ACA values than arboreal ones. The evolution of longer spinules and smaller scales was correlated with high hydrophobicity. These results suggest that hydrophobicity has coevolved with terrestrial microhabitat use in Australian geckos via selection for long spinules and small scales, likely to keep their skin clean and prevent fouling and disease.
More Related Videos
08:02Rendering SiO2/Si Surfaces Omniphobic by Carving Gas-Entrapping Microtextures Comprising Reentrant and Doubly Reentrant Cavities or Pillars
Published on: February 11, 2020
10:52Preparation and High-temperature Anti-adhesion Behavior of a Slippery Surface on Stainless Steel
Published on: March 29, 2018
Related Concept Videos
Adaptations that Reduce Water Loss
Osmoregulation in Insects
Accessory Structures of the Skin: Hair and Hair Follicles
Hair is a keratinous filament growing out of the epidermis. It is primarily made of dead, keratinized cells. Hair strands originate at the epidermal penetration called the hair follicle. The hair shaft is the part...
Biosynthesis of Lipids
Accessory Structures of the Skin: Sweat Glands
Sweat glands are classified as merocrine glands; that is, the secretions are excreted by exocytosis through a duct without affecting the cells of the gland. There...
Glycocalyx and its Functions