Quantitative Structure-Property Relationship Study for Prediction of Boiling Point and Enthalpy of Vaporization of

Fatemeh Ghaemdoost1, Fatemeh Shafiei1

  • 1Department of Chemistry, Arak Branch, Islamic Azad University, Arak,Iran.

Abstract

Related Concept Videos

Physical Properties of Alkanes02:33

Physical Properties of Alkanes

Alkanes are nonpolar molecules due to the presence of only carbon and hydrogen atoms. The electronegativity difference between carbon and hydrogen is minimal, and hence alkanes have a zero dipole moment. This leads to the presence of only dispersion forces between the molecules. The strength of dispersion forces is dependent on the surface area of the molecules on which they act. Since the surface area increases with the molecular length for straight-chain alkanes, the dispersion forces also...
13.6K
Structure and Bonding of Alkenes02:47

Structure and Bonding of Alkenes

Olefins, which are unsaturated hydrocarbons containing one or more carbon–carbon double bonds, are broadly divided into alkenes and cycloalkenes. The general chemical formula of an alkene is CnH2n.
Doubly bonded carbons are sp2 hybridized and have a trigonal planar geometry. The double bond is composed of a σ bond formed by the overlap of hybrid orbitals and a π bond produced by the lateral overlap of unhybridized 2p orbitals on both the carbons. Each carbon atom is...
19.9K
Standard Enthalpy of Formation02:37

Standard Enthalpy of Formation

Enthalpy changes are typically tabulated for reactions in which both the reactants and products are at the same conditions. A standard state is a commonly accepted set of conditions used as a reference point for the determination of properties under other different conditions. For chemists, the IUPAC standard state refers to materials under a pressure of 1 bar and solutions at 1 M and does not specify a temperature. Many thermochemical tables list values with a standard state of 1 atm. Because...
47.6K
Physical Properties of Ethers02:17

Physical Properties of Ethers

Overview
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
8.2K
Relative Stabilities of Alkenes01:59

Relative Stabilities of Alkenes

The relative stability of alkenes can be determined by comparing their heats of hydrogenation. The lower heat of hydrogenation indicates the more stable alkene.  The three main factors determining the relative stability of alkenes are i) the number of substituents attached to the double-bond carbon atoms, ii) hyperconjugation, and iii) the stereochemistry of the double bond.
15.4K
Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes02:14

Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes

The low reactivity in alkanes can be attributed to the non-polar nature of C–C and C–H σ bonds. Alkanes, therefore, were  initially termed as “paraffins,” derived from the Latin words: parum, meaning “too little,” and affinis, meaning “affinity.”
Alkanes undergo combustion in the presence of excess oxygen and high-temperature conditions to give carbon dioxide and water. A combustion reaction is the energy source in natural gas, liquified...
7.5K