Electrochemical Performance Evaluation of Bipolar Membrane Using Poly(phenylene oxide) for Water Treatment System

This study describes the use of poly(phenylene oxide) polymer-based ion-exchange polymers, polystyrene-based ion-exchange particles and a porous support for fabricating bipolar membranes and the results of an assessment of the applicability of these materials to water splitting. In order to achieve good mechanical as well as good ion-exchange properties, bipolar membranes were prepared by laminating poly(phenylene oxide) and polystyrene based ion-exchange membranes with a sulfonated polystyrene-block-(ethylene-ran-butylene)-block-polystyrene) (S-SEBS) modified interface. PE pore-supported ion-exchange membranes were also used as bipolar membranes. The tensile strength was 13.21 MPa for the bipolar membrane which utilized only a cation/anion-exchange membrane. When ion-exchange nanoparticles were introduced for high efficiency, a reduction in the tensile strength to 6.81 MPa was observed. At the same time, bipolar membrane in the form of a composite membrane using PE support exhibited the best tensile strength of 32.41 MPa. To confirm the water-splitting performance, an important factor for a bipolar membrane, pH changes over a period of 20 min were also studied. During water slitting using CA-P-PE-BPM, the pH at the CEM part and the AEM part changed from 5.4 to 4.18 and from 5.4 to 5.63, respectively.