Minimally invasive intraoral proportional condylectomy with a three-dimensionally printed cutting guide

The aim of this study was to describe the steps of a minimally invasive surgical technique used to perform a proportional intraoral condylectomy with a three-dimensionally (3D) printed cutting guide. The technique consists of two steps: virtual surgical planning and intraoral condylectomy. During virtual surgical planning, the mandibular ramus was measured bilaterally, the height of the proportional condylectomy was planned virtually, and a cutting guide was 3D printed. In the intraoral condylectomy, the mandibular condyle was approached intraorally, the 3D printed cutting guide was positioned in the sigmoid notch, and the proportional condylectomy was performed. The protocol reported in this technical note is the sum of knowledge acquired from a series of studies published previously by the authors, who have jointly developed a surgical technique that is both minimally invasive and accurate for the treatment of condylar hyperplasia.