Related Experiment Video

Updated: Dec 14, 2025

Temperature-Controlled Assembly and Characterization of a Droplet Interface Bilayer
10:11

Temperature-Controlled Assembly and Characterization of a Droplet Interface Bilayer

Published on: April 19, 2021

4.1K

Differential temperature control in heat-integrated pressure-swing distillation for separating azeotropes to deal

Yongchao He1, Ye Li1, Kaitian Zheng1

  • 1School of Chemical Engineering and Technology, Chemical Engineering Research Center and State Key Laboratory of Chemical Engineering, Tianjin University, Tianjin 300350, China.

Data in Brief
|July 18, 2020
PubMed

Keywords:
Binary azeotropesDifferential temperature controlHeat-integratedPressure-swing distillation

More Related Videos

Experimental System of Solar Adsorption Refrigeration with Concentrated Collector07:18

Experimental System of Solar Adsorption Refrigeration with Concentrated Collector

Published on: October 18, 2017

14.9K
High-pressure Sapphire Cell for Phase Equilibria Measurements of CO2/Organic/Water Systems05:46

High-pressure Sapphire Cell for Phase Equilibria Measurements of CO2/Organic/Water Systems

Published on: January 24, 2014

13.8K

Related Concept Videos

Distillation: Vapor–Liquid Equilibria01:01

Distillation: Vapor–Liquid Equilibria

Distillation is a separation technique that takes advantage of the boiling point properties of disparate elements in a mixture. To perform distillation, we begin by heating a miscible mixture of two liquids with a significant difference in boiling points (at least 20°C). As the solution heats up and reaches the bubble point of the more volatile component, some molecules of the more volatile component transition into the gas phase and travel upward into the condenser, which is a glass tube...
4.1K
Joule-Thomson Effect01:21

Joule-Thomson Effect

The Joule-Thomson effect, also known as the Joule-Kelvin effect, describes the temperature change of a fluid when it is forced through a valve or porous plug while keeping it in a thermally insulated environment. This experiment is called a throttling process. This is an important effect widely used in refrigeration and the liquefaction of gases.
This experiment forces high-pressure gas through a throttle valve or a porous plug to a lower-pressure region. The gas expands as it passes through to...
8.3K
Clausius-Clapeyron Equation02:35

Clausius-Clapeyron Equation

The equilibrium between a liquid and its vapor depends on the temperature of the system; a rise in temperature causes a corresponding rise in the vapor pressure of its liquid. The Clausius-Clapeyron equation gives the quantitative relation between a substance’s vapor pressure (P) and its temperature (T); it predicts the rate at which vapor pressure increases per unit increase in temperature.
61.8K
Phase Diagram01:19

Phase Diagram

The phase of a given substance depends on the pressure and temperature. Thus, plots of pressure versus temperature showing the phase in each region provide considerable insights into the thermal properties of substances. Such plots are known as phase diagrams. For instance, in the phase diagram for water (Figure 1), the solid curve boundaries between the phases indicate phase transitions (i.e., temperatures and pressures at which the phases coexist).
6.8K
PID Controller01:19

PID Controller

Proportional-Integral-Derivative (PID) controllers are widely used in various control systems to enhance stability and performance. In a thermostat, it adjusts heating or cooling based on the temperature difference between the actual and desired levels. They are often used in automotive speed systems, effectively managing sudden speed changes while maintaining a constant speed under varying conditions. On the other hand, PI controllers, commonly employed in voltage regulation, enhance stability...
517
Isochoric and Isobaric Processes01:21

Isochoric and Isobaric Processes

A thermodynamic process that occurs at constant volume is called an isochoric process. According to the first law of thermodynamics, heat supplied or removed from the system is partially utilized to perform work and change the internal energy of the system. However, in an isochoric process, the volume remains constant. Hence, the work done by the system is zero. Therefore, the exchange of heat changes the internal energy of the system only. 
Suppose 1000 g of water is heated from 40...
4.1K