Related Experiment Video
Updated: Dec 14, 2025

Preparation and Reactivity of a Triphosphenium Bromide Salt: A Convenient and Stable Source of PhosphorusI
Published on: November 22, 2016
Bis(4-methyl phenyl)iodonium as an alternative component to diphenyliodonium in camphorquinone-based ternary
Karina C Verzola1, Diogo Dressano2, Cintia Helena Coury Saraceni1
1Dental Research Division, Paulista University, Rua Doutor Bacelar, 1212, CEP: 04026-002 Sao Paulo, Brazil.
Objective:
To evaluate the influence of different co-initiators (diphenyliodonium hexafluorophosphate - DPI - and bis(4-methyl phenyl)iodonium hexafluorophosphate - BPI) on chemical and mechanical properties of resins.
Methods:
Nine experimental resins (50% Bis-GMA and 50% TEGDMA, w/w) with 60 wt% filler particles were formulated. The initiating system used was camphorquinone (CQ-1 mol%) and ethyl dimethylaminobenzoate (EDAB-2 mol%). Experimental groups were established according to DPI and BPI quantities (0.25, 0.5, 0.75, and 1 mol%). The control group was a resin containing only CQ-EDAB. Light transmission through the resin during polymerisation was analysed with a UV-vis spectrophotometer. Real-time polymerisation of the systems was evaluated using an FTIR spectrometer. Real-time polymerisation shrinkage strain was evaluated, and the flexural strength and modulus of materials were obtained by 3-point bending. Experimental groups were statistically analysed by Analysis of Variance and Tukey's test (α = 0.05). Dunnett's test was applied to compare experimental groups with control.
Results:
Light transmission rapidly increased initially for resins containing DPI or BPI. After 30 s cure, the irradiance on the lower surface of resin specimens was similar for all groups. After 10 s of light irradiation, groups containing DPI and BPI had higher conversion than the control. However, conversion after 120 s post-irradiation was similar for all groups. The rate of polymerisation, shrinkage strain, and the maximum strain rate were higher for groups containing DPI/BPI. The use of iodonium salts increased the flexural strength and flexural moduli of resins.
Significance:
DPI and BPI increased resin reactivity similarly. Increased rate of polymerization influenced light transmission through the resin in the first seconds of polymerisation and increased resin shrinkage and rate of shrinkage, as well as flexural strength and moduli.
Related Concept Videos
Electrophilic Aromatic Substitution: Fluorination and Iodination of Benzene
Diazonium Group Substitution with Halogens and Cyanide: Sandmeyer and Schiemann Reactions
Nucleophilic Aromatic Substitution of Aryldiazonium Salts: Aromatic SN1
In the Sandmeyer reaction, for example, the diazonio group is replaced by a chloro, bromo,...
ortho–para-Directing Activators: –CH3, –OH, –⁠NH2, –OCH3
Diazonium Group Substitution: –OH and –H
Radical Substitution: Hydrogenolysis of Alkyl Halides with Tributyltin Hydride
The bonds formed in this reaction are stronger than the bonds broken, making it energetically favorable. The reaction follows a radical chain mechanism similar to radical halogenation reactions,...

