Using Monte Carlo methods for H_p(0.07) values assessment during the handling of ¹⁸F-FDG

The dose limit for the skin of the hand is typically converted to a surface of 1 cm², which means that one needs to measure point doses in different places on the hand. However, the commonly used method of measuring doses on the hand, i.e., using a dosimetric ring including one or several thermoluminescent detectors worn at the base of a finger, is not adequate for manual procedures such as labeling or radiopharmaceutical injection. Consequently, the purpose of this study was to create and conduct a series of computer simulations that, by recreating the actual working conditions, would provide information on the values of ionizing radiation doses received by the most exposed parts of the hands of employees of radiopharmaceutical production facilities, as well as those of nurses during the injection of radiopharmaceuticals. The simulations were carried out using Monte Carlo radiation transport calculations. The H_p(0.07) personal dose equivalent values obtained for the fingertips of the index and middle fingers of nursing staff and chemists were within the range limited by the minimum and maximum H_p(0.07) values obtained as a result of dosimetric measurements carried out in diagnostic and production centers. Only in the case of the nurse's fingertip, the simulated value of H_p(0.07 slightly exceeded the measured maximum H_p(0.07) value. The comparison of measured and simulated dose values showed that the largest differences in H_p(0.07) values occurred at the thumb tip, and for ring finger and middle finger of some of the nurses investigated.