Related Experiment Video
Updated: Dec 11, 2025

Setup of Consumer Wearable Devices for Exposure and Health Monitoring in Population Studies
Published on: February 3, 2023
Real-Time Estimation of the Short-Run Impact of COVID-19 on Economic Activity Using Electricity Market Data
Carlo Fezzi1,2, Valeria Fanghella1
1Department of Economics and Management, University of Trento, Via Vigilio Inama 5, 38122 Trento, Italy.
Abstract:
In response to the COVID-19 emergency, many countries have introduced a series of social-distancing measures including lockdowns and businesses' shutdowns, in an attempt to curb the spread of the infection. Accordingly, the pandemic has been generating unprecedented disruption on practically every aspect of society. This paper demonstrates that high-frequency electricity market data can be used to estimate the causal, short-run impacts of COVID-19 on the economy, providing information that is essential for shaping future lockdown policy. Unlike official statistics, which are published with a delay of a few months, our approach permits almost real-time monitoring of the economic impact of the containment policies and the financial stimuli introduced to address the crisis. We illustrate our methodology using daily data for the Italian day-ahead power market. We estimate that the 3 weeks of most severe lockdown reduced the corresponding Italian Gross Domestic Product (GDP) by roughly 30%. Such negative impacts are now progressively declining but, at the end of June 2020, GDP is still about 8.5% lower than it would have been without the outbreak.
Related Concept Videos
Power System Three-Phase Short Circuits
Econometric Views (EViews)
Steps in Outbreak Investigation
Electrical Power
Three-Phase Short Circuit—Unloaded Synchronous Machine
This behavior occurs due to the magnetic flux produced by the short-circuit armature currents. Initially, these currents follow high-reluctance paths but eventually shift to...
Bus Impedance Matrix
In the first circuit, all machine voltage sources are short-circuited, leaving only the prefault voltage source at the fault location. The positive-sequence bus impedance matrix can be determined by solving the nodal equations,...

