Three-dimensional analysis of spinal deformity correction in adolescent idiopathic scoliosis: comparison of two...

To compare 3D postoperative deformity correction using two distinct commonly utilized techniques for the treatment of adolescent idiopathic scoliosis (AIS).

AIS patients with major thoracic (Lenke 1-2) curves at two sites who underwent deformity correction via posterior spinal instrumented fusion using one of two distinct techniques were retrospectively reviewed. Patients were matched 1:1 between sites for Lenke type (95% Lenke 1) and follow-up time. The "band site" performed posteromedial translation using thoracic sublaminar bands and 5.5-mm rods. The "screw site" performed spine derotation using differential rod contouring with pedicle screws and 5.5-mm rods. 3D measures of deformity from spinal reconstructions were compared between sites.

Preoperatively, the groups had similar thoracic curve magnitudes (band, 55 ± 12° vs. screw, 52 ± 10°; p > 0.05); the "screw site" had less T5-T12 kyphosis (2 ± 14° vs. 7 ± 12°, p = 0.05) and greater thoracic apical rotation (- 19 ± 7° vs. - 14 ± 8°, p = 0.007). Postoperatively, the "screw site" had greater percent correction (61% vs. 76%, p < 0.001) and kyphosis restoration (p = 0.002). The groups achieved a similar amount of apical derotation (p = 0.9). The "band site" used cobalt chromium rods exclusively; the "screw site" used cobalt chromium (3%) and stainless steel (97%; p < 0.001). The "band site" performed significantly longer fusions.

Significant variations were found between two commonly utilized techniques in AIS surgery, including rod material, correction mechanisms, and fusion levels. Significantly, a greater 3D deformity correction of the coronal and sagittal planes was observed at the "screw site" compared to the "band site", but with no difference in axial plane correction.