Related Experiment Video
Updated: Dec 10, 2025
Author Spotlight: Three-Dimensional Cephalometric Landmark Annotation Demonstration on Human Cone Beam Computed Tomography Scans
Published on: September 8, 2023
Three-Dimensional Analysis of Craniofacial Structures of Individuals With Nonsyndromic Unilateral Complete Cleft Lip
Shahistha Parveen1, Akhter Husain1, Gejo Johns1
1Department of Orthodontics and Dentofacial Orthopedics, Yenepoya Dental College, Mangalore.
Abstract:
Cleft lip and palate (CLP) is one of the most common congenital deformities. Primary surgeries at an early age result in scar formation, which may impede the growth of craniofacial structures of the maxilla. Orthodontist's role in the management of individuals with CLP is important and starts from the time of birth. The knowledge of craniofacial structures in individuals with a cleft is essential for treatment planning. The purpose of this study was to analyze and compare craniofacial structures of cleft and noncleft side of individuals with non-syndromic unilateral complete cleft lip and palate (NSUCCLP) using cone-beam computed tomography (CBCT). CBCT scans of individuals with NSUCCLP (n = 42) were retrieved from the databases of two cleft centers, which followed the same protocols for timing and type of primary surgeries and secondary alveolar bone grafting (SABG). DICOM files of CBCT scans were integrated into Dolphin 3D software, and analysis was carried out in multiplanar views. The craniofacial structures of individuals with NSUCCLP were analyzed using fourteen parameters. Measurements were also recorded between the cleft and noncleft sides for comparison. The volume of the maxilla was generated by isolating it from adjacent structures on a 3D reconstructed model. MAWC, MAWPM1, MAWPM2, MAWM1, and MV of the cleft side was less than noncleft side (P < 0.05). MHP @ N Aper is less on the noncleft side (P < 0.05). There is an asymmetry of structures around the dentoalveolar and nasal region; however, asymmetries were not affected at deeper structures of the craniofacial region of individuals with NSUCCLP.
Related Concept Videos
01:27Cranial Bones: Lateral View
The temporal bone forms the lower lateral side of the skull. The temporal bone is subdivided into several regions. The flattened upper portion is the squamous portion of the temporal bone. Below this area and projecting anteriorly is the zygomatic process of the temporal bone, which forms the posterior portion of the zygomatic arch. Posteriorly is the mastoid portion of the temporal bone. Projecting...
01:14Cranial Bones: Superior and Posterior View
The frontal bone is the single bone that forms the forehead. At its anterior midline, between the eyebrows, there is a slight depression called the glabella. The frontal bone also forms the supraorbital margin of the orbit. Near the middle of this margin is the supraorbital foramen, the opening that provides passage for a sensory nerve to the forehead. The frontal bone is thickened just above each supraorbital margin,...
01:22Sutures of the Skull
Sutures are immobile joints between adjacent bones of the skull. The narrow gap between the bones is filled with dense, fibrous connective tissue that unites the bones. The long sutures located between the skull bones are not straight but instead follow irregular, tightly twisting paths. These twisting lines tightly...