Related Experiment Video

Updated: Dec 9, 2025

Reservoir Condition Pore-scale Imaging of Multiple Fluid Phases Using X-ray Microtomography
08:02

Reservoir Condition Pore-scale Imaging of Multiple Fluid Phases Using X-ray Microtomography

Published on: February 25, 2015

12.9K

Spatial distribution, structural characterization and weathering of tarmats along the west coast of Qatar

S Veerasingam1, Jassim A Al-Khayat1, K P Haseeba1

  • 1Environmental Science Center, Qatar University, P.O. Box: 2713, Doha, Qatar.

Marine Pollution Bulletin
|September 7, 2020
PubMed

Keywords:
ATR-FTIRSpectral indicesTarmatWeatheringWest coast of Qatar

More Related Videos

Dynamic Pore-scale Reservoir-condition Imaging of Reaction in Carbonates Using Synchrotron Fast Tomography10:18

Dynamic Pore-scale Reservoir-condition Imaging of Reaction in Carbonates Using Synchrotron Fast Tomography

Published on: February 21, 2017

8.8K
Visualizing Methane-Cycling Microbial Dynamics in Coastal Wetlands07:26

Visualizing Methane-Cycling Microbial Dynamics in Coastal Wetlands

Published on: January 31, 2025

700

Related Concept Videos

Porosity and Absorption of Aggregate01:20

Porosity and Absorption of Aggregate

Aggregates contain pores of varying sizes; while some are completely enclosed within the particles, others open onto the surface, allowing water to penetrate. The porosity of aggregates is a major factor contributing to the overall porosity of concrete, given that aggregates constitute about three-quarters of concrete's volume.
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
618
Pore Size Distribution01:23

Pore Size Distribution

In concrete, the pore size distribution significantly influences the material's properties. Capillary pores, markedly larger than gel pores, form a vast network within partially hydrated cement paste, reducing the concrete's strength and increasing its permeability. This heightened permeability leads to a greater risk of damage from environmental factors like freeze-thaw cycles and chemical attacks, with the extent of vulnerability also being tied to the water-to-cement ratio.
Adequate...
312
Green Algae01:21

Green Algae

Green algae, also referred to as chlorophytes, are different from red algae in having the chloroplasts containing chlorophylls a and b, which give them their distinct green hue. However, they lack phycobiliproteins, preventing them from developing the red or blue-green pigmentation seen in red algae. In terms of photosynthetic pigment composition, green algae closely resemble plants and share a close evolutionary relationship with them. Taxonomically Green algae belong to Phylum Chlorophyta in...
534
Masonry in Cold and Hot Weather Conditions01:21

Masonry in Cold and Hot Weather Conditions

In cold weather, masonry construction requires specific precautions to ensure mortar does not freeze before curing, as this can significantly weaken its strength and watertightness. Mortar temperature should be maintained between 60°F and 80°F to support proper hydration and curing. Below 40°F, mortar water must be heated, but should not exceed 120°F as high temperatures can reduce mortar's compressive and bond strength.
Other key practices include keeping masonry units...
246
Mortar Joint Deterioration in Masonry01:13

Mortar Joint Deterioration in Masonry

Mortar joint deterioration is a significant concern in masonry structures, with water accumulation in the joints leading to damage from freeze-thaw cycles. The repeated expansion of water during freezing and its melting during thawing develop and propagate cracks in the masonry joints. Eventually, this leads to the spalling of mortar from the joints, loosening masonry units and weakening the structure. The deteriorated mortar joints are also vulnerable to moisture intrusion into the walls.
The...
249
Unsoundness of Aggregate due to Volume Change01:26

Unsoundness of Aggregate due to Volume Change

Unsoundness in aggregates due to volume changes is primarily caused by the physical alterations aggregates undergo, such as freezing and thawing, thermal changes, and wetting and drying. Unsound aggregates, when subjected to these changes, result in volume change upon disintegration. This, in turn, contributes to the deterioration of concrete, including scaling, pop-outs, and cracking. Particular types of aggregates, such as porous flints, cherts, and those containing clay minerals, are...
287