Related Experiment Video
Updated: Dec 9, 2025

Challenges in Rheological Characterization of Highly Concentrated Suspensions — A Case Study for Screen-printing Silver Pastes
Published on: April 10, 2017
Effect of particle size, concentration, temperature and pH on rheological properties of shallots flour
1Department of Food Engineering, Indian Institute of Food Processing Technology, Thanjavur, 613005 India.
Abstract:
Shallot flour was prepared and sieved into three different particle sizes of < 180 μm (sample A), 180 μm (sample B) and 250 μm (sample C). Effect of concentration [0.5%, 1.0%, 1.5% and 2.0% (w/w)], temperature (20, 30, 40, 60 and 80 °C), pH (4, 7 and 10) and freezing (- 20 °C) on rheological properties of shallot flour were studied at increasing shear of 0.1-100 s-1. Effect of dynamic change in temperature (15-95 °C) was also measured at constant shear rate of 50 s-1. Power law (Eq. 2) model with coefficient of determination (R2) above 0.90, well described the rheological behavior of the shallot flour as a shear thinning, non-Newtonian fluid at different concentration, temperature and pH. All the samples had n values below 1 and increase in viscosity or consistency index (k) value with increase in concentration of the sample was observed, while inverse relation was observed when temperature was increased. All samples showed increase in k value when the pH of the dispersion was varied from acidic to alkaline condition. Viscosity of samples were found unaffected even after freezing in freeze-thaw cycle. These data show sample A to be most suitable for their application as thickener, having highest k value. The obtained research provides information for utilization of shallot as a thickener in various food industries.
Related Concept Videos
Factors Affecting Dissolution: Particle Size and Effective Surface Area
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
Colloids
Stress Concentrations in Circular Shafts
Pharmaceutical Alternatives: Polymorphic Form-Related and Particle Size-Related Therapeutic Nonequivalence

