Enhancing Antibacterial Performance and Biocompatibility of Pure Titanium by a Two-Step Electrochemical Surface...

A two-step electrochemical surface treatment has been developed to modify the CP Ti surface on commercially pure titanium grade 2 (CP Ti): (1) anodic oxidation to form TiO₂ nanotube precoatings loaded with silver (Ag) and (2) microarc oxidation (MAO) to produce a porous Ca-P-Ag coating in an electrolyte containing Ag, Ca, and P. One-step MAO in the same electrolyte has also been used to produce porous Ca-P-Ag coatings without anodic oxidation and preloaded Ag as a control. Surface morphologies and alloying chemistry of the two coatings were characterized by SEM, EDS, and XPS. Biocompatibility and antimicrobial properties have been evaluated by the MTT method and co-culture of Staphylococcus aureus, respectively. It is demonstrated that porous coatings with high Ag content can be achieved on the CP Ti by the two-step treatment. The optimized MAO voltage for excellent comprehensive properties of the coating is 350 V, in which a suitable chemical equilibrium between Ag, Ca, and P contents and a Ca/P ratio of 1.67 similar to HA can be obtained, and the Ag particles are in the size of less than 100 nm and embedded into the underneath of the coating surface. After being contacted with S. aureus for 1 and 7 days, the average bactericidal rates were 99.53 and 89.27% and no cytotoxicity was detected. In comparison, the one-step MAO coatings contained less Ag, had a lower Ca/P ratio, and showed lower antimicrobial ability than the two-step treated samples.