Bonding crowns and bridges with resin cement: An American Dental Association Clinical Evaluators Panel survey

Bonding crowns and bridges with resin cement can improve retention and reinforcement of the restoration. However, there is variation in the steps taken by different practitioners to achieve this goal.

The authors developed a survey on bonding dental crowns and bridges with resin cement and distributed it electronically to the American Dental Association Clinical Evaluators (ACE) Panel on May 22, 2020. The survey remained open for 2 weeks. Descriptive data analysis was conducted using SAS Version 9.4.

A total of 326 panelists responded to the survey, and 86% of respondents who place crowns or bridges use resin cements for bonding. When placing a lithium disilicate restoration, an almost equal proportion of respondents etch it with hydrofluoric acid in their office or asked the laboratory to do it for them, and more than two-thirds use a silane primer before bonding. For zirconia restorations, 70% reported their restorations are sandblasted in the laboratory, and 39% use a primer containing 10-methacryloyloxydecyl dihydrogen phosphate. One-half of respondents clean their lithium disilicate or zirconia restorations with a cleaning solution. Resin cements used with a primer in the etch-and-rinse mode are the most widely used. The technique used to cure and clean excess resin cement varies among respondents.

The types of resin cements used, tooth preparation, crown or bridge preparation, and bonding technique vary among this sample.

Although many dentists bond crowns and bridges on the basis of best practices, improvement in the process may be achieved by dentists communicating with their laboratory to confirm the steps performed there, ensuring an effective cleaning technique is used after try-in and verifying that the correct primer is used with their chosen restorative material.