Related Experiment Video
Updated: Dec 6, 2025
Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material
Published on: December 20, 2024
Marginal and Internal Adaptation of Lithium Disilicate Endocrowns Fabricated By Heat-Pressable and Subtractive
1Department of Prosthodontics, Faculty of Dental Medicine, Lebanese University, Beirut, Lebanon.
Purpose:
To evaluate and to compare the marginal and the internal fit of milled (MLE) and heat-pressed lithium disilicate endocrowns (PLE).
Materials And Methods:
Thirty mandibular molars were prepared following the circumferential butt margin endocrown preparations; the cervical margin is parallel to the occlusal surface without ferrule design. A digital scan of molars was made using an intraoral digital scanner. The samples were separated into two groups (n = 15 per group); MLE: endocrowns were milled using LDS blocks and a 5-axis milling machine, PLE: endocrowns were heat-pressed using lost wax technique and LDS ingots. Marginal and internal adaptation were assessed using a replica technique and a stereomicroscope, selecting 32 measurements on each endocrown. Data were analyzed with one-way repeated measures ANOVA, two-way repeated measures ANOVA, student's t-test and paired student t-test (α = 0.05).
Results:
Statistically significant interactions were recorded between fabrication technique and region (p < 0.05), F (1.97, 27.69) = 5.462. Group MLE displayed significantly smaller gaps than PLE in all regions (p < 0.001). The largest gap was observed at the pulpal floor in both groups. The internal gap was significantly larger than the marginal gap in MLE group (p < 0.001), while no statistically significant difference was observed in PLE group (p = 0.082).
Conclusion:
Heat-pressed and milled lithium disilicate endocrowns are clinically suitable, but the milled technique displayed a better fit than heat-pressed technique when marginal and internal adaptation were examined.
