Related Experiment Video

Updated: Dec 1, 2025

Methods of Ex Situ and In Situ Investigations of Structural Transformations: The Case of Crystallization of Metallic Glasses
08:55

Methods of Ex Situ and In Situ Investigations of Structural Transformations: The Case of Crystallization of Metallic Glasses

Published on: June 7, 2018

8.8K

Anharmonicity and Phase Diagram of Magnesium Oxide in the Megabar Regime

François Soubiran1,2,3, Burkhard Militzer1,4

  • 1Department of Earth and Planetary Science, University of California, Berkeley, California 94720, USA.

Physical Review Letters
|November 6, 2020
PubMed

More Related Videos

Analyzing Melts and Fluids from Ab Initio Molecular Dynamics Simulations with the UMD Package06:37

Analyzing Melts and Fluids from Ab Initio Molecular Dynamics Simulations with the UMD Package

Published on: September 17, 2021

4.8K
Bulk and Thin Film Synthesis of Compositionally Variant Entropy-stabilized Oxides09:41

Bulk and Thin Film Synthesis of Compositionally Variant Entropy-stabilized Oxides

Published on: May 29, 2018

9.8K

Related Concept Videos

Phase Diagram01:19

Phase Diagram

The phase of a given substance depends on the pressure and temperature. Thus, plots of pressure versus temperature showing the phase in each region provide considerable insights into the thermal properties of substances. Such plots are known as phase diagrams. For instance, in the phase diagram for water (Figure 1), the solid curve boundaries between the phases indicate phase transitions (i.e., temperatures and pressures at which the phases coexist).
6.7K
Phase Diagrams02:39

Phase Diagrams

A phase diagram combines plots of pressure versus temperature for the liquid-gas, solid-liquid, and solid-gas phase-transition equilibria of a substance. These diagrams indicate the physical states that exist under specific conditions of pressure and temperature and also provide the pressure dependence of the phase-transition temperatures (melting points, sublimation points, boiling points). Regions or areas labeled solid, liquid, and gas represent single phases, while lines or curves represent...
47.1K
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
14.2K
Chemical Equilibria: Systematic Approach to Equilibrium Calculations01:21

Chemical Equilibria: Systematic Approach to Equilibrium Calculations

Equilibrium calculations for systems involving multiple equilibria are often complex. For example, to calculate the solubility of a sparingly soluble salt in an aqueous solution in the presence of a common ion, one must consider all the equilibria in this solution. Calculations for these systems can be complicated and tedious, so a systematic approach with a series of steps is often helpful. The process is detailed below.
The first step is to identify all the chemical reactions involved, The...
1.2K
States of Matter and Phase Changes00:59

States of Matter and Phase Changes

The internal energy of a substance—the total kinetic energy of all its molecules and the potential energy of their associated forces—depends on the strength of the intermolecular forces in the condensed phases and the pressure exerted on the substance. The internal energy of a substance is the highest in the gaseous state, the lowest in the solid state, and intermediate in the liquid state. Phase transitions are caused by changes in physical conditions, such as temperature and...
3.0K
Ladder Diagrams: Complexation Equilibria01:07

Ladder Diagrams: Complexation Equilibria

Ladder diagrams are useful for evaluating equilibria involving metal-ligand complexes. The vertical scale of the ladder diagram represents the concentration of unreacted or free ligand, pL. The horizontal lines on the scale depict the log of stepwise formation constants for metal-ligand complexes and indicate the dominant species in all the regions.
The formation constant, K1, for the formation of Cd(NH3)2+ complex from cadmium and ammonia is 3.55 × 102. Log K1 (i.e. pNH3) is 2.55, and...
519