Related Experiment Video

Updated: Dec 1, 2025

Simulation, Fabrication and Characterization of THz Metamaterial Absorbers
13:44

Simulation, Fabrication and Characterization of THz Metamaterial Absorbers

Published on: December 27, 2012

15.7K

Admittance analysis of broadband omnidirectional near-perfect absorber in epsilon-near-zero mode

Wei-Bo Liao, Cheng-Chung Lee, Ya-Chen Chang

    Applied Optics
    |November 11, 2020
    PubMed

    More Related Videos

    Using Microwave and Macroscopic Samples of Dielectric Solids to Study the Photonic Properties of Disordered Photonic Bandgap Materials10:35

    Using Microwave and Macroscopic Samples of Dielectric Solids to Study the Photonic Properties of Disordered Photonic Bandgap Materials

    Published on: September 26, 2014

    12.6K
    Characterization of Anisotropic Leaky Mode Modulators for Holovideo09:36

    Characterization of Anisotropic Leaky Mode Modulators for Holovideo

    Published on: March 19, 2016

    8.2K

    Related Concept Videos

    UV–Vis Spectroscopy: Beer–Lambert Law01:09

    UV–Vis Spectroscopy: Beer–Lambert Law

    The Beer-Lambert law describes the relationship between absorbance and concentration, which combines the principles established by scientists Johann Heinrich Lambert and August Beer. Lambert's law states that when light passes through a medium, the loss in intensity is directly proportional to the original intensity and the path length of the light. Beer's law proposed that the transmittance of a solution remains constant if the product of concentration and path length is constant. The modern...
    5.9K
    UV–Vis Spectrum01:30

    UV–Vis Spectrum

    When light passes through a substance, a portion of the light is absorbed while the remaining light is reflected or transmitted. If the molecule absorbs light between the wavelengths of 180–400 nm range, the UV spectrum is obtained, and if it absorbs light in the 400–780 nm wavelength range, the visible spectrum is obtained.     
    The UV–Vis spectrum of a molecule is the plot of its absorbance versus wavelength. The plot is drawn by taking molar...
    1.7K
    Impedances and Admittance01:23

    Impedances and Admittance

    In the realm of AC circuits, passive circuit elements like resistors, inductors, and capacitors take on a different character when characterized by phasor voltage and current. Their behavior is expressed through impedance, a vital concept in AC circuit analysis.
    Impedance is a measure of resistance to sinusoidal current flow in an AC circuit. Unlike their behavior in DC circuits, where inductors appear as short circuits and capacitors as open circuits, the behavior of these components in AC...
    1.7K
    Atomic Absorption Spectroscopy: Interference01:25

    Atomic Absorption Spectroscopy: Interference

    Interference leads to systematic error in atomic absorption (AA) measurements by enhancing or diminishing the analytical signal or the background. These interferences can be grouped into three main categories: spectral interference, chemical interference, and physical interference.
    Spectral interference occurs when signals from other elements or molecules overlap with the analyte signal, falsely elevating or masking the analyte's absorbance. This interference can be corrected using Zeeman,...
    1.8K
    Parallel Resonance01:23

    Parallel Resonance

    The parallel RLC circuit is an arrangement where the resistor (R), inductor (L), and capacitor (C) are all connected to the same nodes and, as a result, share the same voltage across them. The parallel RLC circuit is analyzed in terms of admittance (Y), which reflects the ease with which current can flow. The admittance is given by:
    392
    Boundary Conditions: Lossless Lines01:21

    Boundary Conditions: Lossless Lines

    Consider a single-phase, two-wire, lossless transmission line terminated by an impedance at the receiving end and a source with Thevenin voltage and impedance at the sending end. The line, with length, has a surge impedance and wave velocity determined by the line's inductance and capacitance.
    At the receiving end, the boundary condition states that the voltage equals the product of the receiving-end impedance and current. This relationship is expressed as a function of the incident and...
    264