Applied anatomical study on suprascapular nerve protection in reverse total shoulder arthroplasty

This study aimed to investigate the three-dimensional (3D) anatomical relationship between the suprascapular nerve and scapula, and the method of protecting the suprascapular nerve in reverse total shoulder arthroplasty (RTSA) METHODS: In the present study, 12 fresh adult cadaver shoulder specimens were dissected. X-ray and computed tomography (CT) were used to investigate the 3D scapular and suprascapular nerve images.

The results revealed that the best fitting baseplate diameter was 24.73 ± 1.56 mm. Furthermore, the baseplate diameter correlated with the glenoid cavity width. After the osteotomy, a simulated screw placement on the baseplate was performed. The dangerous area for the posterior screw placement was at the angle between the upper edge and transverse axis exceeding 38° and between the lower edge and transverse axis exceeding 76°. The distance between the nearest point of the nerve and osteotomy plane was 15.38 ± 2.02 mm, and the angle between the projection point of the nearest point and transverse axis was 27.33 ± 7.96°, which was the dangerous area for retractor placement. The suitable angle between the superior screw and longitudinal axis was 21.67 ± 13.27°, and the suitable superior screw length was 34.66 ± 2.41 mm.

In RTSA, the baseplate size correlates with the glenoid cavity width. The relationship between the screw and suprascapular nerve and retractor placement position should be carefully considered to avoid damaging the suprascapular nerve.