Related Experiment Video
Updated: Nov 29, 2025

Multiscale Sampling of a Heterogeneous Water/Metal Catalyst Interface using Density Functional Theory and Force-Field Molecular Dynamics
Published on: April 12, 2019
Molecular modelling techniques for predicting liquid-liquid interfacial properties of methanol plus alkane (n-hexane,
Esteban Cea-Klapp1, José Manuel Míguez, Paula Gómez-Álvarez
1Department of Chemical Engineering, Universidad de Concepción, Concepción 4070386, Chile. josemagarrido@udec.cl.
Abstract:
In this work, the liquid-liquid interfacial properties of methanol plus n-alkane (n-hexane, n-heptane, n-octane) mixtures are investigated at atmospheric pressure by two complementary molecular modelling techniques; namely, molecular dynamic simulations (MD) and density gradient theory (DGT) coupled with the PC-SAFT (perturbed-chain statistical associating fluid theory) equation of state. Furthermore, two molecular models of methanol are used, which are based on a non-polarisable three site approach. On the one hand, is the original (flexible) TraPPE-UA model force field. On the other hand, is the rigid approximation denoted as OPLS/2016. In both cases, n-alkanes are modelled using the TraPPE-UA model. Simulations are performed using the direct coexistence technique in the ensemble. Special attention is paid to the comparison between the estimations obtained from different methanol models, the available experimental data and theoretical calculations. In all cases, the rigid model is capable of predicting the experimental phase equilibrium and interfacial properties accurately. Unsurprisingly, the methanol-rich density and interfacial tension are overestimated using the TraPPE model combined with Lorentz-Berthelot mixing rules for predicting the mixture behaviour. Accurate comparison between MD and DGT plus PC-SAFT requires consideration of the cross-interactions between individual influence parameters and fitting the βij values. This latter aspect is particularly important because it allows the exploitation of the link between the EOS model and the direct molecular simulation of the corresponding fluid. At the same time, it was demonstrated that the key property defining the interfacial tension value is the absolute concentration of methanol in the methanol-rich phase. This behaviour indicates that there are more hydrogens bonded with each other, and they interact favourably with an increasing number of carbon atoms in the alkane.
More Related Videos
09:32A New Straightforward Method for Lipophilicity logP Measurement using 19F NMR Spectroscopy
Published on: January 30, 2019
07:31Author Spotlight: Advancing Cell Membrane Biophysics - Exploring Interactions and Challenges Through Experimental and Computational Approaches
Published on: September 1, 2023
Related Concept Videos
Intermolecular Forces and Physical Properties
Comparing Intermolecular Forces: Melting Point, Boiling Point, and Miscibility
Temporary attractive forces like dispersion are present in all molecules, whether they are polar or nonpolar. They...
Physical Properties of Alkanes
Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
Ideal Solutions
Physical Properties of Alcohols and Phenols
Alcohols possess a higher boiling point than aliphatic hydrocarbons of similar...