Potential of a New Cone-Beam CT Software for Blooming Artifact Reduction

This study evaluated the dimensions of intraradicular posts using a new cone beam CT (CBCT) software, and verified the potential of blooming artifact reduction. Sixty-three single-rooted human teeth were shaped, obturated, prepared for intracanal post placement and distributed into three groups: G1: anatomically customized prefabricated glass fiber posts; G2: low-fusion alloy posts; G3: gold alloy posts. After post fabrication and luting with RelyX U200®, specimens were sectioned axially at 9 mm from the root apex, and markings were made on the root surfaces (X-, Y- and Z-axes). The dimensions of the original posts (control group) were measured using a digital micrometer. CBCT scans of the teeth were obtained using a PreXion 3D Elite® scanner. Posts were measured on CBCT scans using DICOM files and the e-Vol DX software. A specific filter, Blooming Artefact Reduction (BAR), was developed to analyze intracanal posts. Statistical data were evaluated using the Van de Waerden nonparametric analysis of variance and, after that, normalized data were analyzed using the Tukey test. The level of significance was set at α = 5%. The measures of the anatomical prefabricated, low-fusion alloy and gold alloy intracanal posts obtained using the e-Vol DX CBCT software and a micrometer were not significantly different (p>0.05). The use of the BAR filter of the e-Vol DX software application did not induce any dimensional differences on CBCT scans of intracanal posts when compared with measurements made with a micrometer on original posts. The use of the BAR filter eliminated blooming artifacts.