Related Experiment Video
Updated: Nov 27, 2025

Metabolic Glycoengineering of Sialic Acid Using N-acyl-modified Mannosamines
Published on: November 25, 2017
Making good's buffers good for freezing: The acidity changes and their elimination via mixing with sodium phosphate
Lukáš Veselý1, Behera Susrisweta1, Dominik Heger1
1Department of Chemistry, Faculty of Science, Masaryk University, Kamenice 5, 625 00 Brno, Czech Republic.
Abstract:
Solutions of three Good's buffers (HEPES, MOPS, and MES), both pure and mixed with sodium phosphate buffers (Na-P), are investigated in terms of the freezing-induced acidity changes in their operational pH ranges. The Good's buffers have the tendency to basify upon freezing and, more intensively, at lower pHs. The acidity varies most prominently in MES, where the change may reach the value of two. Importantly, the Good's buffers are shown to mitigate the strong acidification in the Na-P buffer. Diverse concentrations of the Good's buffers are added to cancel out the strong, freezing-induced acidity drop in 50 mM Na-P that markedly contributes to the solution's acidity; the relevant values are 3 mM HEPES, 10 mM MOPS, and 80 mM MES. These buffer blends are therefore proposed to be applied in maintaining approximately the acidity of solutions even after the freezing process and, as such, should limit the stresses for frozen chemicals and biochemicals.
More Related Videos
13:46Separation of Single-stranded DNA, Double-stranded DNA and RNA from an Environmental Viral Community Using Hydroxyapatite Chromatography
Published on: September 29, 2011
08:21Optimized Procedure for Determining the Adsorption of Phosphonates onto Granular Ferric Hydroxide using a Miniaturized Phosphorus Determination Method
Published on: May 18, 2018
Related Concept Videos
Phosphate Buffer
Sodium dihydrogen phosphate does not fully dissociate in neutral or acidic solutions. When a strong base, such as sodium hydroxide (NaOH), is introduced into the solution, sodium dihydrogen phosphate...
Buffers
Buffers: Overview
Buffer Effectiveness
The buffer capacity is the amount of acid or base that can be added to a given volume...
Calculating pH Changes in a Buffer Solution
Titration of a Weak Base with a Strong Acid
Using the ICE table and substituting the Kb value, we calculate the initial pH of 50 mL of 0.1 M ammonia to be 11.11. Addition of 25 mL of 0.1 M hydrochloric acid to this solution of ammonia results in a buffer with an equal concentration of ammonia and ammonium ions. The pH of this buffer can be calculated by substituting these...