Intensification and optimization of biodiesel production using microwave-assisted acid-organo catalyzed...

To produce biodiesel cost-effective, low-cost, high free fatty acid (FFA) oil feedstock is desirable. But high FFA creates difficulty during the base-catalyzed transesterification process by yield loss due to the formation of soap. However, these problems are overcome by the use of an acid catalyst. The acid catalysts can directly convert both triglycerides and FFAs into biodiesel without the formation of soaps or emulsions. The shortcomings of mostly used inorganic acids are that they work well for esterification of FFA present in low-cost oil, but their kinetics for transesterification of triglycerides present in oils is considerably slower. Corrosion of equipment is another major problem associated with an inorganic acid catalyst. The usage of an organic acid catalyst of the alkyl benzene sulfonic type, like 4-dodecyl benzene sulfonic acid (DBSA) minimizes these disadvantages of inorganic acid-catalyzed transesterification. The aim of the present investigation was to reduce the reaction time of transesterification of triglycerides further by using microwaves as a heating source in the presence of DBSA catalyst to achieve higher conversions under mild operating conditions. To optimize the transesterification variables for the higher conversion of biodiesel, the response surface methodology was employed to design the experiment. By using the DBSA catalyst under microwave heating at a temperature of 76 °C, conversion close to 100% in only 30 min of reaction time was obtained using a 0.09 molar ratio of catalyst to oil and 9.0 molar ratio of methanol to oil. A modified polynomial model was developed and was adequately fitted with the experimental data and could be used for understanding the effect of various process parameters. The catalyst to oil molar ratio and reaction temperature created a stronger effect on the biodiesel production than that exhibited by the methanol to oil molar ratio. It was observed that the microwave heating process outperformed conventional heating, providing a rapid, easy method for biodiesel synthesis from triglycerides in the presence of DBSA, an organic acid catalyst. The produced biodiesel was of good quality, as all the properties were within the prescribed limits of the ASTM D6751 standard.