Related Experiment Video
Updated: Nov 26, 2025

Mimicking and Measuring Occlusal Erosive Tooth Wear with the "Rub&Roll" and Non-contact Profilometry
Published on: February 2, 2018
Erosive assessment of dry mouth lozenges and tablets on enamel and dentin
Alex Delgado1, A P Dias Ribeiro1, M Aslam2
1Division of Operative Dentistry, Department of Restorative Dental Science, University of Florida, College of Dentistry, Gainesville, FL, USA.
Objectives:
To assess the erosive potential of dry mouth lozenges and tablets on enamel and dentin.
Materials And Methods:
The following lozenges and tablets were tested: Salese, Oracoat Xylimelts, Cotton Mouth, TheraBreath, DenTek OraMoist, SmartMouth, ACT, CVS Health, Rite Aid, Med Active, and Hager Pharma. pH Analysis: Each lozenge or tablet was crushed with a pestle and mortar and 5 g of the resultant powder was dissolved in 10 ml of distilled water (pH 7.02) The pH of each lozenge solution was assessed by using a calibrated pH meter. Titratable Acidity (TA) was determined by adding 0.1 M of NaOH to each homogenous tablet solution until the pH reached 7.0. Gravimetric Analysis was measured with freshly extracted molars crown/roots were sectioned at the CEJ and enamel and dentin specimens were fabricated. The specimens were then submerged in 5 ml of solution containing 2.5 gm of crushed tablets for 24 h, 48 h, 96 h and 14 days with measurements performed at each interval after drying. The solutions were renewed at each interval.
Results:
Significant correlation between pH and TA was observed for lozenges and tablets evaluated (p < 0.0001). Both variables were strongly correlated with enamel and dentin loss (p < 0.0001). For enamel, DenTek resulted in significantly more substance loss (p < 0.05) than with the other tested products, while Xylimelts presented the lowest percentage of substance loss. For dentin, Cotton Mouth resulted in the highest substance loss, and Xylimelts presented the lowest percentage of substance loss.
Conclusions:
There is a strong correlation between the pH, tritatable aciditiy, and erosive potential of these products. DenTek and Cotton Mouth reported erosive effect to the enamel and dentin, respectively. Xylimelts performed better than the rest of the products in relationship to enamel and dentin.
Related Concept Videos
Assessment of the Mouth
Mouth Inspection
The inspection begins with visually examining the mouth for symmetry, color, and size.
Oral Cavity
Teeth: The teeth are the hardest structures in our bodies. Humans have two sets of teeth throughout their lifetime: deciduous (baby) teeth and permanent teeth. Each tooth consists of several parts: the crown (visible part), the root (embedded in the jaw), enamel (hard outer...
Salivary Glands and Saliva
Tooth Anatomy
The Crown, Neck, and Root
The visible part of the tooth is referred to as the crown. It's covered by enamel, the hardest substance in the human body. The crown is uniquely shaped for each type of tooth, allowing for different functions such as cutting, tearing, or...

