Related Experiment Video
Updated: Nov 22, 2025

Comparison of Kinetic Characteristics of Footwork during Stroke in Table Tennis: Cross-Step and Chasse Step
Published on: June 16, 2021
A kinetic and kinematic comparison of the two-footed and step-out back handsprings on the balance beam
Carlie J Ede1, Maurice R Yeadon1, Michael J Hiley1
1School of Sport, Exercise & Health Sciences, Loughborough University, Loughborough, UK.
Abstract:
The back handspring is one of the most commonly performed skills on the balance beam in women's gymnastics. Despite this, quantitative research on the beam has often been overlooked. This study aimed to investigate the kinetic and kinematic variables during the performance of two back handspring techniques on the beam: the back handspring with two footed landing and the back handspring step-out. A modified balance beam was fixed to a force plate with an isolated mat for landing to allow analysis of the take-off and hand contact phases. Kinetic and kinematic data were recorded for twelve gymnasts performing both techniques. No statistically significant differences between techniques were found during take-off. However, average peak vertical and horizontal ground reaction forces (4.1 bodyweights ± 1.1 BW, and 0.7 BW ± 0.2 BW, respectively) were higher and time to peak force shorter during the hand contact phase for the two footed variant. A more vertical trajectory, along with a greater hand contact ground reaction force were found in comparison to the back handspring performed on the floor. These results highlight the need for more specific investigation to understand the factors which could contribute to reducing the load faced during balance beam performance.
Related Concept Videos
Rigid Body Equilibrium Problems - II
Consider two children sitting on a seesaw, which has negligible mass. The first child has a mass (m1) of 26 kg and sits at point A, which is 1.6 meters (r1) from the pivot point B; the second child has a mass (m2) of 32 kg and sits at point C. How far from the pivot point B should the second child sit (r2) to balance the seesaw?
Energy Diagrams - I
Take the example of a skater on a parabolic ramp. The potential energy at different points along the ramp will be proportional to the height of the ramp, which varies quadratically with the horizontal position on the ramp. As the skater moves down the ramp from the highest position,...
Kinematic Equations: Problem Solving
Kinematic Equations - II
Suppose a car merges into freeway traffic on a 200 m long ramp. If its initial velocity is 10 m/s and it accelerates at 2 m/s2, then the...
Steps for Free-Body Diagram
To find the acceleration of the system, it is first necessary to calculate the net force on the system. In order to accomplish this, a free-body diagram can be created to...
Energy Diagrams - II
The point in the energy diagram at which the system’s potential energy is the lowest is known as the local minima. The system tends to stay in this position indefinitely unless acted upon by a net force. The slope of the potential energy diagram at the local minima is zero, indicating that zero net force is acting on the system. The...

