Related Experiment Video
Updated: Nov 21, 2025

Sandy Soil Improvement through Microbially Induced Calcite Precipitation MICP by Immersion
Published on: September 12, 2019
Effects of poly-γ-glutamic acid and poly-γ-glutamic acid super absorbent polymer on the sandy loam soil
Jianzhong Guo1, Wenjuan Shi1, Jiake Li1
1State Key Laboratory of Eco-hydraulics in Northwest Arid Region of China, Xi'an University of Technology, Xi'an, China.
Abstract:
The main forms of poly-γ-glutamic acid (γ-PGA) applied in agriculture include agricultural γ-PGA and γ-PGA super absorbent polymer (SAP). Laboratory experiments were conducted with a check treatment CK (no γ-PGA added) and two different forms of γ-PGA added to sandy loam soil (T and TM stand for γ-PGA and γ-PGA SAP) at four different soil mass ratios (0.05% (1), 0.10% (2), 0.15% (3) and 0.20% (4)) to determine their effects on sandy loam soil hydro-physical properties. Both of them could reduce the cumulative infiltration of soil water. The total available water (TAW) which the soil water content (SWC) from field water capacity (FC) to permanent wilting point (PWP) after γ-PGA added into sandy loam soil had no significant different compared with CK, and the TAW was highest at the treatment of γ-PGA with 0.10% addition amount into sandy loam soil. However, the TAW of sandy loam soil increased dramatically with the γ-PGA SAP addition amount increasing. TM3 had the highest soil water absorption among the treatments with γ-PGA SAP. The T1 to T4 treatments with γ-PGA addition slightly prolonged retention time (RT) when SWC varied from FC to PWP compared with CK. For γ-PGA SAP addition treatments, the time for SWC varied from FC to PWP was 1.48 times (TM1), 1.88 times (TM2), 2.01 times (TM3) and 2.87 times (TM4) longer than that of CK, respectively. The results of this study will provide further information for the use of these materials in agricultural application.
More Related Videos
06:10Extraction of Structural Extracellular Polymeric Substances from Aerobic Granular Sludge
Published on: September 26, 2016
08:59Synthesizing a Gel Polymer Electrolyte for Supercapacitors, Assembling a Supercapacitor Using a Coin Cell, and Measuring Gel Electrolyte Performance
Published on: November 30, 2022
Related Concept Videos
Superplasticizers
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
Factors Influencing Drug Absorption: Physicochemical Parameters
Enhanced drug absorption can be achieved by reducing particle sizes and increasing surface areas, thereby facilitating...
Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...
Plasticizers
Plasticizers function by using surface-active agents to create repulsive electrostatic forces between cement particles. This dispersion enhances the concrete's...