Related Experiment Video
Updated: Nov 20, 2025

Forming Micro-and Nano-Plastics from Agricultural Plastic Films for Employment in Fundamental Research Studies
Published on: July 27, 2022
Effect of microplastic particle size to the nutrients removal in activated sludge system
Yanjiao He1, Lu Li2, Kang Song2
1School of Materials Science and Chemical Engineering, Anhui Jianzhu University, Hefei 230022, China; State Key Laboratory of Freshwater Ecology and Biotechnology, Institute of Hydrobiology, Chinese Academy of Sciences, Wuhan 430072, China.
Abstract:
Microplastics as emerging environmental pollutants, its effect to the bioprocess of water and wastewater treatment has aroused concern. This study investigated the effects of microplastic polystyrene (PS) particle size to the activated sludge nutrient removal process. The ammonia, nitrite, nitrate and phosphorus removal under various PS particle size during nitrification and denitrification process was tested. The results indicated that with PS particle size 150-300 μm, the ammonia oxidation during nitrification process was inhibited to 71%, 92%, and 80% as compared with the blank reactor, for PS concentration at 0.01 g/L, 0.05 g/L and 0.10 g/L, respectively. The nitrite accumulation during nitrification process was also high at PS particle size 150-300 μm and concentration no less than 0.05 g/L. The nitrate reduction during the denitrification process was all inhibited to 69%-94% as compared with the blank, except for reactor No.4. The phosphate removal during nitrification process was not affected by the existence of microplastics PS, the average removal rate was over 80% after 2 h and over 95% after 3 h, respectively. The microplastics particle size plays important role in affecting the activated sludge nutrient removal process.
Related Concept Videos
Factors Affecting Dissolution: Particle Size and Effective Surface Area
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...

