PCA Model of Fundamental Acoustic Finger Force for Out-of-Plane Ultrasonic Vibration and its Correlation with...

When a finger touches an ultrasonic vibrating plate, a non-sinusoidal contact force is produced. This force is called acoustic finger force. In a setup where closed-loop control is performed on the vibration amplitude, a component of the acoustic finger force can be measured at the fundamental vibration frequency of the plate. This calculation is obtained from the measurement of the variation of the controller voltage between the no-load case and when a finger is present. This calculation is made for a group of twelve participants. From these results a PCA (Principal Component Analysis) model is created. This model permits estimation of the acoustic finger force response of a participant at any vibration amplitude, based on a one or two point measurement. Finally, a linear relation between the PCA coefficients and the friction reduction is proposed. The objective of this relation would be to ultimately provide the means to create an amplitude reference calibration based on the desired friction reduction level, and thus be able to produce a standardized tactile feedback for each user, despite the biomechanical differences in finger pad properties between subjects.