Related Experiment Video
Updated: Nov 16, 2025

Optimized Fabrication Procedure for High-Quality Graphene-based Moiré Superlattice Devices
Published on: July 11, 2025
Higher-Order Band Topology in Twisted Moiré Superlattice
Bing Liu1, Lede Xian2, Haimen Mu1
1Hefei National Laboratory for Physical Sciences at the Microscale, CAS Key Laboratory of Strongly-Coupled Quantum Matter Physics, Department of Physics, University of Science and Technology of China, Hefei, Anhui 230026, China.
Abstract:
The two-dimensional (2D) twisted bilayer materials with van der Waals coupling have ignited great research interests, paving a new way to explore the emergent quantum phenomena by twist degree of freedom. Generally, with the decreasing of twist angle, the enhanced interlayer coupling will gradually flatten the low-energy bands and isolate them by two high-energy gaps at zero and full filling, respectively. Although the correlation and topological physics in the low-energy flat bands have been intensively studied, little information is available for these two emerging gaps. In this Letter, we predict a 2D second-order topological insulator (SOTI) for twisted bilayer graphene and twisted bilayer boron nitride in both zero and full filling gaps. Employing a tight-binding Hamiltonian based on first-principles calculations, three unique fingerprints of 2D SOTI are identified, that is, nonzero bulk topological index, gapped topological edge state, and in-gap topological corner state. Most remarkably, the 2D SOTI exists in a wide range of commensurate twist angles, which is robust to microscopic structure disorder and twist center, greatly facilitating the possible experimental measurement. Our results not only extend the higher-order band topology to massless and massive twisted moiré superlattice, but also demonstrate the importance of high-energy bands for fully understanding the nontrivial electronics.
Related Concept Videos
Bewley Lattice Diagram
Mohr's Circle for Plane Strain
Mohr's circle visually represents the strain states under various conditions, which is essential for...
Superposition Theorem for AC Circuits
The principle of superposition stipulates that the output of a linear circuit with several concurrent inputs is equivalent to the...
Lattice Centering and Coordination Number
Types of Unit Cells
Imagine taking a large number of identical...
¹H NMR: Interpreting Distorted and Overlapping Signals
As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are...
Second-Order Circuits
Input signals typically originate from voltage or current sources, with the output often representing voltage across the capacitor and/or current through the inductor. For example, in...

