Related Experiment Video
Updated: Nov 14, 2025

Investigating the Three-dimensional Flow Separation Induced by a Model Vocal Fold Polyp
Published on: February 3, 2014
Aerodynamic investigation of tucked positions in alpine skiing
Ola Elfmark1, Knut Erik Teigen Giljarhus2, Fredrik Fang Liland3
1Norwegian University of Science and Technology, Department of Civil and Environmental Engineering, N-7491 Trondheim, Norway.
Abstract:
The purpose of this investigation was to examine the aerodynamics of tucked positions in competitive alpine skiing. To further our understanding of how a skier's position affects the air flow and the resulting aerodynamic drag, a combination of both experimental and simulation methods was used. This study focused in particular on the effect of skier torso and thigh angles relative to the air flow direction, as these two angles have been previously found to be important determinants of aerodynamic performance in tucked positions. Two top 30 world-ranked skiers were investigated in two different wind tunnels, and the results were compared with Computational Fluid Dynamics (CFD) simulations performed using a 3D scan of one of the athlete. To quantify the effect of torso and thigh angles on skier drag, changes in drag were measured relative to baseline positions. Skier drag area increased by approximately 0.8 and 1.2% per degree increase in torso and thigh angles relative to the baseline position, respectively. This trend was consistent between both of the experimental wind tunnel tests as well as the CFD simulations, indicating good agreement between methods. The CFD simulations further indicated that the air flow about the lower legs made the largest contribution to skier drag, accounting for as much as 40-50% of the total drag area in low tuck positions. Based on these findings, a low tuck position where the torso angle approaches 0° and the knees help to fill the gap behind the armpits will minimize skier aerodynamic drag.
More Related Videos
Related Concept Videos
Lift
Energy Diagrams - II
The point in the energy diagram at which the system’s potential energy is the lowest is known as the local minima. The system tends to stay in this position indefinitely unless acted upon by a net force. The slope of the potential energy diagram at the local minima is zero, indicating that zero net force is acting on the system. The...
Work Done Over an Inclined Plane
The work done by gravity to move a rigid body, or the work done by an opposing force to move a rigid body against gravity, can be calculated using the center-of-mass framework. It is the line integral of the force of gravity over the path, considered positive if...
Collisions in Multiple Dimensions: Problem Solving
A small car of mass 1,200 kg traveling east at 60 km/h collides at an intersection with a truck of mass 3,000 kg traveling due north at 40 km/h. The two vehicles are locked together. What is the...
Thin-Walled Hollow Shafts
Elevation of Intermediate Points on Vertical Curves

