Correlations Between Radial Head Diameters and Humeral Articular Dimensions: Bilateral MRI Morphometric Analysis on...

Choosing the correct size of head component in radial head arthroplasty is often challenging, particularly in comminuted fractures, deformities, and revision surgery. The main aim of this study was to investigate possible correlations between radial head diameters and the morphometric parameters of the articular distal humerus in order to find mathematical equations that may be used to infer radial head dimensions indirectly.

We performed bilateral elbow magnetic resonance imaging on 39 healthy young subjects, comprising 19 women and 20 men, with a mean age of 28 years (range, 21-32 years). The following measurements, which included cartilage thickness, were calculated on the axial plane: maximum (Dmax) and minimum (Dmin) radial head diameters, capitellum width, capitellum to lateral trochlear ridge width (CAP-TROCHridge), humeral articular width (HUMwidth), capitellum radius of curvature, and lateral, medial, and total trochlear width. The anteroposterior diameters of the capitellum, trochlear sulci, and lateral and medial trochlear ridges were measured on the sagittal plane.

CAP-TROCHridge and HUMwidth were found to be the parameters most strongly correlated with the radial head diameters. Four mathematical equations that allowed Dmax and Dmin to be calculated with an average residual error less than 1 mm, were obtained. The intraclass coefficient was greater than 0.95 for all the measurements.

Radial head diameters can be accurately inferred from 2 humeral dimensions by magnetic resonance imaging. The HUMwidth, which is not influenced by cartilage thickness, may be useful for planning with preoperative imaging because it can also be calculated by computed tomography scan, whereas CAP-TROCHridge, which is influenced by cartilage thickness, might be useful for direct intraoperative measurement.

Diagnostic III.