On measuring agreement with numerically bounded linguistic probability schemes: A re-analysis of data from Wintle,

David R Mandel1, Daniel Irwin2

  • 1Intelligence, Influence and Collaboration Section, Toronto Research Centre, Defence Research and Development Canada, Toronto, Ontario, Canada.

Plos One
|March 18, 2021
PubMed

Related Concept Videos

Ordinal Level of Measurement00:55

Ordinal Level of Measurement

The way a set of data is measured is called its level of measurement. Correct statistical procedures depend on a researcher being familiar with levels of measurement. For analysis, data are classified into four levels of measurement—nominal, ordinal, interval, and ratio.
Data measured using an ordinal scale are similar to nominal scale data, but there is one major difference. The ordinal scale data can be ordered. An example of ordinal scale data is a list of the top five national parks in the...
Nominal Level of Measurement00:56

Nominal Level of Measurement

The way a set of data is measured is called its level of measurement. Correct statistical procedures depend on a researcher being familiar with levels of measurement. Not every statistical operation can be used with every set of data. For analysis, data are classified into four levels of measurement—nominal, ordinal, interval, and ratio.
The data that cannot be measured but can be grouped into categories fall under the nominal level of measurement. Data that is measured using a nominal scale is...
Interpretation of Confidence Intervals01:19

Interpretation of Confidence Intervals

A confidence interval is a better estimate of the population than a point estimate, as it uses a range of values from a sample instead of a single value.
Confidence intervals have confidence coefficients that are crucial for their interpretation. The most common confidence coefficients are 0.90, 0.95, and 0.99, which can be written as percentages–90%, 95%, and 99%, respectively.
Suppose a person calculates a confidence interval with a confidence coefficient of 0.95. In that case, they can...
Accuracy, limits, and approximation01:28

Accuracy, limits, and approximation

Accuracy, limits, and approximations are common in many fields, especially in engineering calculations. These concepts are imperative for ensuring that a given value is as close as possible to its true value.
Accuracy is defined as the closeness of the measured value to the true or actual value. In engineering mechanics, repeated measurements are taken during theoretical or experimental analyses to ensure that the result is precise and accurate.
The accuracy of any solution is based on the...
Statistical Analysis: Overview01:11

Statistical Analysis: Overview

When we take repeated measurements on the same or replicated samples, we will observe inconsistencies in the magnitude. These inconsistencies are called errors. To categorize and characterize these results and their errors, the researcher can use statistical analysis to determine the quality of the measurements and/or suitability of the methods.
One of the most commonly used statistical quantifiers is the mean, which is the ratio between the sum of the numerical values of all results and the...
Kendall's Coefficient of Concordance01:20

Kendall's Coefficient of Concordance

Kendall's Coefficient of Concordance (W), also known as Kendall's W, is a non-parametric statistical measure used to assess the agreement or concordance between multiple raters or judges when they rank a set of items. It is often used when you have ordinal data (ranks) and you want to see if there is consistency or consensus among the raters. It is widely applied in research areas such as psychology, medicine, and social sciences, where multiple judges are asked to rank or rate subjects or...