Related Experiment Video

Updated: Nov 10, 2025

Phase Diagram Characterization Using Magnetic Beads as Liquid Carriers
12:37

Phase Diagram Characterization Using Magnetic Beads as Liquid Carriers

Published on: September 4, 2015

12.7K

Physicochemical Characterization and Simulation of the Solid-Liquid Equilibrium Phase Diagram of Terpene-Based

Maha M Abdallah1,2, Simon Müller3, Andrés González de Castilla3

  • 1iBET, Instituto de Biologia Experimental e Tecnológica, Apartado 12, 2781-901 Oeiras, Portugal.

Molecules (Basel, Switzerland)
|April 3, 2021
PubMed

Keywords:
chemical interactionsdeep eutectic solventsequilibrium phase diagramphysical characterizationsimulationterpenes

More Related Videos

Preparation of Binary and Ternary Deep Eutectic Systems06:15

Preparation of Binary and Ternary Deep Eutectic Systems

Published on: October 31, 2019

12.4K
High-pressure Sapphire Cell for Phase Equilibria Measurements of CO2/Organic/Water Systems05:46

High-pressure Sapphire Cell for Phase Equilibria Measurements of CO2/Organic/Water Systems

Published on: January 24, 2014

13.7K

Related Concept Videos

Distillation: Vapor–Liquid Equilibria01:01

Distillation: Vapor–Liquid Equilibria

Distillation is a separation technique that takes advantage of the boiling point properties of disparate elements in a mixture. To perform distillation, we begin by heating a miscible mixture of two liquids with a significant difference in boiling points (at least 20°C). As the solution heats up and reaches the bubble point of the more volatile component, some molecules of the more volatile component transition into the gas phase and travel upward into the condenser, which is a glass tube...
3.8K
Phase Diagrams02:39

Phase Diagrams

A phase diagram combines plots of pressure versus temperature for the liquid-gas, solid-liquid, and solid-gas phase-transition equilibria of a substance. These diagrams indicate the physical states that exist under specific conditions of pressure and temperature and also provide the pressure dependence of the phase-transition temperatures (melting points, sublimation points, boiling points). Regions or areas labeled solid, liquid, and gas represent single phases, while lines or curves represent...
46.3K
Ideal Solutions02:24

Ideal Solutions

According to Raoult’s law, the partial vapor pressure of a solvent in a solution is equal or identical to the vapor pressure of the pure solvent multiplied by its mole fraction in the solution. However, Raoult's Law is only valid for ideal solutions. For a solution to be ideal, the solvent-solute interaction must be just as strong as a solvent-solvent or solute-solute interaction. This suggests that both the solute and the solvent would use the same amount of energy to escape to the...
21.5K
Entropy and Solvation02:05

Entropy and Solvation

The process of surrounding a solute with solvent is called solvation. It involves evenly distributing the solute within the solvent. The rule of thumb for determining a solvent for a given compound is that like dissolves like. A good solvent has molecular characteristics similar to those of the compound to be dissolved. For example, polar solutions dissolve polar solutes, and apolar solvents dissolve apolar solutes. A polar solvent is a solvent that has a high dielectric constant (ϵ...
7.8K
Recrystallization: Solid–Solution Equilibria01:10

Recrystallization: Solid–Solution Equilibria

Recrystallization is a purification technique used to separate impurities from solid compounds. In this technique, no chemical reactions occur. Instead, it exploits physical properties only, specifically, the solubility differences between the desired compound and impurities, either at a single temperature or at different temperatures, and under other selected conditions. The solid-solution equilibrium (solubility equilibrium) of each component in the solution represents a binary phase...
1.6K
Phase Diagram01:19

Phase Diagram

The phase of a given substance depends on the pressure and temperature. Thus, plots of pressure versus temperature showing the phase in each region provide considerable insights into the thermal properties of substances. Such plots are known as phase diagrams. For instance, in the phase diagram for water (Figure 1), the solid curve boundaries between the phases indicate phase transitions (i.e., temperatures and pressures at which the phases coexist).
6.4K