Aqueous Phase Behavior of a NaLAS-Polycarboxylate Polymer System

Linear alkylbenzene sulfonate (NaLAS) surfactant is often combined with polycarboxylate polymers in detergent formulations. However, the behavior of these aqueous surfactant-polymer systems in the absence of an added electrolyte is unreported. This work investigates the behavior of such systems using polarized light microscopy, small-angle X-ray scattering (SAXS), centrifugation, and ²H NMR techniques. A phase diagram at 50 °C is reported for 0-50 wt % NaLAS concentrations and 0-10 wt % polycarboxylate concentrations. The NaLAS-water system is micellar at concentrations <35 wt %, and a 2-phase micellar-lamellar system is seen at higher NaLAS levels, consistent with that reported by previous studies. As polymers are added at low surfactant concentrations (∼10 to 20 wt % NaLAS), a second optically isotropic phase is formed; this is thought to be a polymer-rich phase. Further addition of polycarboxylate leads to the formation of a lamellar phase. At high surfactant concentrations (>20 wt % NaLAS), the addition of a polymer induces a second lamellar phase. These observed behaviors are thought to arise as a result of depletion flocculation and salting-out effects. The observed lamellar phases adopt colloidal multilamellar vesicle (MLV) structures, and the average MLV radii were estimated using ²H NMR by probing the diffusion and anisotropy of D₂O within the bilayers of the vesicles. The NMR results show that as the polymer concentration was increased from 0 to 10 wt %, an increase in the average multilamellar vesicle size from ∼200 to ∼500 nm was observed. This increase in the calculated average MLV radius likely results from depletion flocculation-induced MLV fusion.