Related Experiment Video
Updated: Aug 17, 2026

Physical, Chemical and Biological Characterization of Six Biochars Produced for the Remediation of Contaminated Sites
Published on: November 28, 2014
Lignite, thermally-modified and Ca/Mg-modified lignite for phosphate remediation
Hasara Samaraweera1, Abigail Sharp2, John Edwards1
1Department of Chemistry, Mississippi State University, Mississippi State, MS, USA.
Abstract:
Aqueous phosphate uptake is needed to reduce global eutrophication. Negatively charged adsorbent surfaces usually give poor phosphate sorption. Chemically- and thermally-modified lignite (CTL) was prepared by impregnating low-cost lignite (RL) with Ca2+ and Mg2+ cations, basified with KOH (pH ̴ 13.9), followed by a 1 h 600 °C pyrolysis under nitrogen. CTL has a positive surface (PZC = 13) due to basic surface Ca and Mg compounds, facilitating the aqueous phosphate uptake. CaCO3, MgO, Ca(OH)2, and Mg(OH)2 surface phases with 0.22 μm particle sizes were verified by XRD, XPS, SEM, TEM, and EDX before and after phosphate uptake. Higher amounts of these mineral phases promoted more CTL phosphate uptake than raw lignite (RL) and thermally treated lignite (TL) without Ca/Mg modification. Phosphorous uptake by Ca2+/Mg2+ occurs not by classic adsorption but by stochiometric precipitation of Mg3(PO4)2, MgHPO4, Ca3(PO4)2, and CaHPO4. This offers the potential of substantial uptake capacities. CTL's phosphate removal is pH-dependent; the optimum pH was 2.2. Water-washed CTL exhibited a maximum Langmuir phosphate uptake capacity of 15.5 mg/g at pH 7, 6 and 14 times higher than that of TL and RL, respectively (particle size <150 μm, adsorbent dose 50 mg, 25 mL of 25-1000 ppm phosphate concentration, 24 h, 25 °C). The unwashed CTL exhibited a maximum Langmuir phosphate removal capacity (80.6 mg/g), 5.2-times greater than the washed CTL (15.5 mg/g). Insoluble Ca2+ and Mg2+ phosphates/hydrophosphate particles dominated CTL's phosphate removal. Phosphates were recovered from both exhausted unwashed and washed CTL better in HCl than in NaOH. P-laden washed CTL exhibited a slow phosphate leaching rate under initial pH of 6.5-7.5 (52-57% over 20 days) after phosphate uptake, indicating it could serve as a slow-release fertilizer. Unwashed CTL retained more phosphates than washed CTL (cumulative qe for 4 cycles = 391.8 mg/g vs 374.7 mg/g) and potentially improves soil fertility more.
More Related Videos
11:14Two-way Valorization of Blast Furnace Slag: Synthesis of Precipitated Calcium Carbonate and Zeolitic Heavy Metal Adsorbent
Published on: February 21, 2017
06:34Operation of a 25 KWth Calcium Looping Pilot-plant with High Oxygen Concentrations in the Calciner
Published on: October 25, 2017
Related Concept Videos
Pozzolans
Fly ash is a...
Microbial Bioremediation of Uranium