Conversational distance adaptation in noise and its effect on signal-to-noise ratio in realistic listening

Adam Weisser1, Kelly Miles1, Michael J Richardson2

  • 1Department of Linguistics, Australian Hearing Hub, Macquarie University, 16 University Avenue, New South Wales 2109, Australia.

Related Concept Videos

Echo01:06

Echo

The human ear cannot distinguish between two sources of sound if they happen to reach within a specific time interval, typically 0.1 seconds apart. More than this, and they are perceived as separate sources.
Imagine the sound is reflected back to the ears. Assuming that the source is very close to the human, the difference between hearing the two sounds—the emitted sound and the reflected sound—may be more than the minimum time for perceiving distinct sounds. If this is the case,...
683
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
7.5K
Sound Intensity Level00:53

Sound Intensity Level

Humans perceive sound by hearing. The human ear helps sound waves reach the brain, which then interprets the waves and creates the perception of hearing. The loudness of the environment in which a person is located determines whether they can distinguish between different sound sources.
The human ear can perceive an extensive range of sound intensity, necessitating the use of the logarithmic scale to define a physical quantity—the intensity level. It is a ratio of two intensities and...
4.5K
Applications of Logarithms01:28

Applications of Logarithms

Logarithmic functions are powerful tools for simplifying the mathematical representation of phenomena involving exponential changes. Their ability to convert multiplicative relationships into additive ones is especially valuable in various scientific and engineering contexts. One notable application of logarithms is measuring sound intensity, specifically through the decibel (dB) scale used in acoustics.Sound intensity levels vary over an extensive range, from the faintest audible whisper to...
50
Interference: Path Lengths01:10

Interference: Path Lengths

Consider two sources of sound, that may or may not be in phase, emitting waves at a single frequency, and consider the frequencies to be the same.
Two special sources may be considered when they are in phase. This can be easily achieved by feeding the two sources from the same source. An example would be synchronizing the two speakers by feeding them with the same source, such as the sound waves produced by a tuning fork. This setup ensures that the two sources have the same frequency and are...
1.6K
Barriers to Effective Communication I01:30

Barriers to Effective Communication I

A communication barrier is any distortion or interruption during a conversation, resulting in miscommunication of the message. A good communicator should know these barriers and continuously check for the listener's understanding by obtaining feedback.
Communication barriers include the following:
Physiological barriers: They are limitations caused by a person's health condition or disability, such as hearing loss, poor eyesight, illness, or unconsciousness. An example to overcome this...
10.4K